[1] Epstein A H,Ffowcs Willianms J E,Greitzer E M.Active suppression of aerodynamic instabilities in turbomachines.Journal of Propulsion and Power,1989,5(2): 204-211.[2] Paduano J D,Epstein A H,Valavani L,et al.Active control of rotating stall in a low-speed axial compressor.ASME Journal of Turbomachinery,1993,115(1): 48-56.[3] Day I J.Active suppression of rotating stall and surge in axial compressors.ASME Journal of Turbomachinery,1993,115(1): 40-47.[4] Weigl H J,Paduano J D,Frechette L G,et al.Active stabilization of rotating stall and surge in a transonic single stage axial compressor.ASME Journal of Turbomachinery,1998,120(4): 625-636.[5] Spakovszky Z S,Weigl H J,Suder K L,et al.Rotating stall control in a high-speed stage with inlet distortion: Part I-Radial distortion.ASME Journal of Turbomachinery,1999,121(3): 510-516.[6] Spakovszky Z S,van Schalkwyk C M,Weigl H J,et al.Rotating stall control in a high speed stage with inlet distortion: Part Ⅱ-Circumferential distortion.ASME Journal of Turbomachinery,1999,121(3): 517-524.[7] McDougall N M,Cumpsty N A,Hynes T P.Stall inception in axial compressors.ASME Journal of Turbomachinery,1990,112(1): 116-125.[8] Day I J.Stall inception in axial flow compressors.ASME Journal of Turbomachinery,1993,115(1): 1-9.[9] Tahara N,Nakajima T,Kurosaki M,et al.Active stall control with practicable stall prediction system using auto-correlation.AIAA-2001-3623,2001.[10] Dhingra M,Neumeier Y,Prasad J V R,et al.A stochastic model for a compressor stability measure.ASME Paper,GT-2006-91182,2006.[11] Christensen D,Cantin P,Gutz D,et al.Development and demonstration of a stability management system for gas turbine engines.ASME Paper,GT-2006-90324,2006.[12] Li L,Nie C Q.On-line measurement and stall control by DSP in single-stage axial compressor.Acta Aeronautica et Astronautica Sinica,2009,30(5): 787-793.(in Chinese) 李琳,聂超群.轴流压气机旋转失速DSP在线控制方法.航空学报,2009,30(5): 787-793.[13] Tong Z T,Li L,Nie C Q,et al.Online stall control with the digital signal processing method in an axial compressor.ASME Paper,GT-2009-59509,2009.[14] Suder K L,Hathaway M D,Thorp S A,et al.Compressor stability enhancement using discrete tip injection.ASME Journal of Turbomachinery,2001,123(1): 14-23.[15] Li J C,Tong Z T,Nie C Q,et al.Detection and analysis of early stall warning base on cross-correlation.Acta Aeronautica et Astronautica Sinica,2013,34(1): 28-36.(in Chinese) 李继超,童志庭,聂超群,等.基于互相关分析的前失速先兆检测分析.航空学报,2013,34(1): 28-36.[16] Li J C,Tong Z T,Lin F,et al.Experimental investigation of tip air injection base on detection mechanism of early stall warning.Journal of Engineering Thermophysics,2012,33(4): 573-577.(in Chinese) 李继超,童志庭,林峰,等.基于前失速先兆检测机理的叶顶喷气扩稳实验研究.工程热物理学报,2012,33(4): 573-577.[17] Du J.Investigation on the unsteady mechanism of tip leakage flow in transonic compressor/fan rotors.Beijing: Institute of Engineering Thermophysics,Chinese Academy of Science,2010.杜娟.跨音压气机/风扇转子叶顶泄漏流动的非定常机制研究,北京: 中国科学院工程热物理研究所,2010.[18] Li J C,Liu L,Tong Z T,et al.Experimental investigation of stability range extension mechanism with tip air injection in a low-speed axial compressor.Asian Congress on Gas Turbines,ACGT-2012-1097,2012.[19] Pramod B S,John J,Pradeep A M.Active feedback control of stall in an axial flow fan under dynamic inflow distortion.Experimental Thermal and Fluid Science,2011,35(6): 1135-1142. |