导航
Archive
Similarity for simulating automatic carrier landing process of full-scale aircraft with scaled-model
ZUO Xianshuai, WANG Lixin, LIU Hailiang, WANG Yun, ZHANG Yu
doi: 10.7527/S1000-6893.2019.23005
2019, (12): 123005-123005.
PDF [ 8035 K ]( 966 ) HTML
Sensibility analysis of heat transfer characteristics to dimensionless criterion in central inlet rotating disk cavity
DING Shuiting, DENG Changchun, QIU Tian
doi: 10.7527/S1000-6893.2019.23017
2019, (12): 123017-123017.
PDF [ 4769 K ]( 190 ) HTML
Aerodynamic characteristics of hovering coaxial rigid rotor in ground effect
LU Congling, QI Haotian, XU Guohua, SHI Yongjie
doi: 10.7527/S1000-6893.2019.23055
2019, (12): 123055-123055.
PDF [ 10596 K ]( 912 ) HTML
Binocular vision-based measurement of dynamic motion for aircraft model suspended by wire system
ZHOU Fangui, WANG Xiaoguang, GAO Zhongxin, LIN Qi
doi: 10.7527/S1000-6893.2019.23059
2019, (12): 123059-123059.
PDF [ 6839 K ]( 594 ) HTML
Measurement technique optimization of turbulence level in compressible fluid by changing overheat ratio of hot wire anemometer
DU Yufeng, LIN Jun, WANG Xunnian, XIONG Neng
doi: 10.7527/S1000-6893.2019.23067
2019, (12): 123067-123067.
PDF [ 3349 K ]( 365 ) HTML
Integrated numerical analysis of fluid-thermal-structural problems in “Type Ⅳ” shock wave interference
LI Jiawei, WANG Jiangfeng, YANG Tianpeng, LI Longfei, WANG Ding
doi: 10.7527/S1000-6893.2019.23190
2019, (12): 123190-123190.
PDF [ 7672 K ]( 537 ) HTML
Boundary layer effects on rules of minimum oblique shock strength
WEN Hao, SHI Aiming, YAN Rong
doi: 10.7527/S1000-6893.2019.23196
2019, (12): 123196-123196.
PDF [ 4424 K ]( 485 ) HTML
Influence of microwave on structure of supersonic combustion flame
MENG Yu, GU Hongbin, ZHANG Xinyu
doi: 10.7527/S1000-6893.2019.23224
2019, (12): 123224-123224.
PDF [ 4270 K ]( 466 ) HTML
Analysis of impact response of mid-fuselage ground arresting in a carrier-based UAV
XIONG Wenqiang, ZHANG Run, ZHANG Xiaoqing, ZHU Xiaolong, GAO Zongzhan, LIU Xiaoming, HE Min, YAO Xiaohu
doi: 10.7527/S1000-6893.2019.22892
2019, (12): 222892-222892.
PDF [ 8514 K ]( 796 ) HTML
A new method for fatigue reliability calculation of aero-engine limited life parts
YOU Lingfei, ZHANG Jianguo, ZHOU Shuang, DU Xiaosong
doi: 10.7527/S1000-6893.2019.23228
2019, (12): 223228-223228.
PDF [ 5812 K ]( 532 ) HTML
Damping performance analysis of friction patches using an accelerated dynamic Lagrange method
MA Haoye, LI Lin, FAN Yu, WU Yaguang
doi: 10.7527/S1000-6893.2019.23283
2019, (12): 223283-223283.
PDF [ 7023 K ]( 380 ) HTML
Remaining useful life prediction method for engine combining multi-sensors data
REN Ziqiang, SI Xiaosheng, HU Changhua, WANG Xi
doi: 10.7527/S1000-6893.2019.23312
2019, (12): 223312-223312.
PDF [ 7005 K ]( 928 ) HTML
Variable sliding mode sliding mode controller for centrifugal harmonic force generator
WANG Wentao, LIU Zhengjiang, LI Xinmin
doi: 10.7527/S1000-6893.2019.23210
2019, (12): 323210-323210.
PDF [ 4658 K ]( 425 ) HTML
Sensitivity analysis of ship formation operational effectiveness based on DBN effectiveness fitting
LI Bo, LUO Haoran, TIAN Linyu, WANG Yuanxun
doi: 10.7527/S1000-6893.2019.23214
2019, (12): 323214-323214.
PDF [ 7151 K ]( 414 ) HTML
ADS-B anomaly data detection model based on deep learning
DING Jianli, ZOU Yunkai, WANG Jing, WANG Huaichao
doi: 10.7527/S1000-6893.2019.23220
2019, (12): 323220-323220.
PDF [ 4798 K ]( 876 ) HTML
Energy-optimal guidance law with virtual hand-over point
LI Chendi, WANG Jiang, LI Bin, HE Shaoming, ZHANG Tong
doi: 10.7527/S1000-6893.2019.23249
2019, (12): 323249-323249.
PDF [ 3928 K ]( 514 ) HTML
Design and verification of two-level error correction coding scheme for stoage systems
LUO Jinfei, ZHAO Shuaibing, QIN Luoyu, WANG Gang, LIU Xiaoguang
doi: 10.7527/S1000-6893.2019.23250
2019, (12): 323250-323250.
PDF [ 4466 K ]( 354 ) HTML
GNSS-R sea surface wind speed inversion based on BP neural network
GAO Han, BAI Zhaoguang, FAN Dongdong
doi: 10.7527/S1000-6893.2019.23261
2019, (12): 323261-323261.
PDF [ 3665 K ]( 603 ) HTML
Diagnosis method for avionics based on membership and LMK-ELM
ZHU Min, XU Aiqiang, LI Ruifeng, DAI Jinling
doi: 10.7527/S1000-6893.2019.23277
2019, (12): 323277-323277.
PDF [ 6805 K ]( 350 ) HTML
Surveillance performance of satellite-based ADS-B system in co-channel interference environment
LIU Haitao, LI Shaoyang, QIN Dingben, LI Dongxia
doi: 10.7527/S1000-6893.2019.23292
2019, (12): 323292-323292.
PDF [ 5675 K ]( 426 ) HTML
Influence of laser power and surface condition on balling behavior in selective laser melting
FENG Yiqi, XIE Guoyin, ZHANG Bi, QIAO Guowen, GAO Shang, BAI Qian
doi: 10.7527/S1000-6893.2019.23089
2019, (12): 423089-423089.
PDF [ 8111 K ]( 634 ) HTML
Residual stress profile and fatigue life of 7050 aluminum plate with groove under laser shot peening
GOU Lei, MA Yu'e, DU Yong, LIU Lei, GUO Chao, LI Gang
doi: 10.7527/S1000-6893.2019.23096
2019, (12): 423096-423096.
PDF [ 6639 K ]( 489 ) HTML
Stringer deformation problems of panels stiffened with hat stringer in autoclave process
XIONG Wenlei, SU Jiazhi, LIU Xiaolin, HAN Xiaoyong, QI Jingge, SONG Tiancheng
doi: 10.7527/S1000-6893.2019.23108
2019, (12): 423108-423108.
PDF [ 6115 K ]( 657 ) HTML
Springback prediction for Z-shaped profiles in roll bending process based on neutral layer shift
WANG Anheng, XUE Hongqian, YANG Yanli, WEI Yaoguang
doi: 10.7527/S1000-6893.2019.23127
2019, (12): 423127-423127.
PDF [ 5349 K ]( 415 ) HTML
Academic Quality
Download Ranking
CJA