航空学报 > 2010, Vol. 31 Issue (1): 210-216

闭式整体叶盘五坐标插铣刀位轨迹规划

任军学, 谢志丰, 梁永收, 姚倡锋, 刘博   

  1. 西北工业大学 现代设计与集成制造技术教育部重点实验室
  • 收稿日期:2009-09-01 修回日期:2009-10-19 出版日期:2010-01-25 发布日期:2010-01-25
  • 通讯作者: 任军学

5-axis Plunge Milling Path Planning of Closed Blisk

Ren Junxue, Xie Zhifeng, Liang Yongshou, Yao Changfeng, Liu Bo   

  1. The Key Laboratory of Contemporary Design and Integrated Manufacturing Technology, Ministry of Education, Northwestern Polytechnical University
  • Received:2009-09-01 Revised:2009-10-19 Online:2010-01-25 Published:2010-01-25
  • Contact: Ren Junxue

摘要: 针对闭式整体叶盘通道开槽工艺问题,研究了叶盘通道五坐标开槽插铣加工方法。进行了闭式叶盘通道可加工性分析,给出了通道加工区域划分方法;基于最小面积原理研究了叶盘插铣通道边界最佳直母线求解算法,分别针对叶片曲面及叶盘内外环面,提出了通道偏置直纹包络面的生成方法,给出了闭式整体叶盘五坐标插铣刀位轨迹。研究结果表明:该方法能解决闭式整体叶盘通道插铣区域划分和直纹包络面生成问题,可有效实现闭式整体叶盘的五坐标开槽粗加工。

关键词: 闭式整体叶盘, 铣削, 边界线, 直纹包络面, 刀位轨迹

Abstract: With regard to the slot process of closed blisk, a 5-axis slot plunge milling method of closed blisk is studied. First, this article analyzes the machinability of blisk channel and proposes the channel region division method. Then, the algorithm to solve the best ruled generatrix of plunging milling channel boundary is presented based on the least area principle. The method is addressed to generate the ruled envelope surfaces in view of blade-offset-surfaces and internal and external ring-offset-surfaces, respectively. 5-axis plunge milling tool path of closed blisk is presented finally. The results show that the channel region division and the ruled envelope surface generating can be solved by this approach, and the slot plunge milling of closed blisk can be achieved effectively.

Key words: closed blisk, milling, boundary line, ruled envelope surface, tool path

中图分类号: