航空学报 > 2015, Vol. 36 Issue (9): 2840-2849   doi: 10.7527/S1000-6893.2015.0055

高温燃气进入舵机舱过程仿真与流动机理分析

李斌1,2, 王学占1, 刘仙名1,2   

  1. 1. 中国空空导弹研究院, 洛阳 471009;
    2. 航空制导武器航空科技重点实验室, 洛阳 471009
  • 收稿日期:2015-01-16 修回日期:2015-03-01 出版日期:2015-09-15 发布日期:2015-03-16
  • 通讯作者: 李斌 男, 博士, 高级工程师。主要研究方向: 导弹气动设计, 计算流体力学。 Tel: 0379-63385270 E-mail: lib_in@163.com E-mail:lib_in@163.com
  • 作者简介:王学占 男, 工程师。主要研究方向: 导弹气动设计, 计算流体力学。 Tel: 0379-63385270 E-mail: wangxuezhan2001@163.com;刘仙名 男, 博士, 研究员。主要研究方向: 导弹总体、气动设计。 Tel: 0379-63384490 E-mail: liuxming@163.com
  • 基金资助:

    航空科学基金 (2014ZA12001)

Numerical investigation and flow mechanism analysis of hot gas entering control section

LI Bin1,2, WANG Xuezhan1, LIU Xianming1,2   

  1. 1. China Airborne Missile Academy, Luoyang 471009, China;
    2. Aviation Key Laboratory of Science and Technology on Airborne Guided Weapons, Luoyang 471009, China
  • Received:2015-01-16 Revised:2015-03-01 Online:2015-09-15 Published:2015-03-16
  • Supported by:

    Aeronautical Science Foundation of China (2014ZA12001)

摘要:

采用计算流体力学(CFD)方法研究了火箭发动机工作拖尾段高温发动机燃气进入舵机舱的物理现象。结合导弹实际飞行弹道参数变化特点和超声速流场扰动不向前传递的空气动力学理论,提出了简化而不失真的非定常流场仿真方案,显著缩短了仿真周期;复现了某型导弹实际飞行时舵机舱先被"抽气"再进高温燃气的动态过程,并分析了高温发动机燃气进入舵机舱的流动机理,即在发动机工作段,导弹底端面压强低于舵机舱内压强,舵机舱被"抽气",在拖尾段随着燃烧室总压降低,喷口附近的马赫盘向导弹底端面移动,使导弹底端面压强增大且高于舵机舱内压强,高温燃气进入舵机舱烧毁电路致使导弹折断;明确了某型导弹折断故障产生的诱因,提出了改进措施和检测方法,并得到了大量飞行靶试的验证,解决了舵机舱热防护结构可靠性问题。

关键词: 火箭发动机, 导弹, 超声速, 非定常流动, 计算流体力学

Abstract:

The phenomenon of hot gas exhausted from the rocket engine flowing into the control section in the burnout phase of a rocket engine is studied using computational fluid dynamics (CFD) method. A simplified simulation method is proposed without much loss in accuracy after analyzing the parameters of the actual trajectory of a missile, based on the aerodynamic theory that disturbance in supersonic flow will not propagate upstream, and it greatly reduce the time cost. The dynamic progress that the air in the control section is first pumped out and the hot gas is sucked in afterward recurred, and flow mechanism is found out: during the working stage of the rocket engine, the air in the control section is pumped out due to the low pressure at the base of the missile, and then along with the reduction in the total pressure in the combustion chamber during the descending stage of the rocket the Mach disk moves towards the base which results in the increase of the base pressure, and finally the hot gas flows into the control section which causes the burning of the circuit board and then the fracture of the missile in the end. Finally the cause of failure is revealed, and the improvement measures and detection method are proposed and then validated in flight tests, the reliability of thermal protection is solved.

Key words: rocket motors, missile, supersonic, unsteady flow, computational fluid dynamics

中图分类号: