单个压电风扇传热特性

doi:10.7527/S1000-6893.2017.120982

Abstract

Abstract:

A numerical simulation of the three-dimensional unsteady flow and heat transfer characteristics of a single piezoelectric fan arranged normally to the heated surface is performed using dynamic meshing scheme. The displacement of the vibrating fan is determined from the vibration test by using the laser doppler vibrameter. An experimental test for the distribution of the local convective heat transfer coefficient is also made using the infrared camera. The distribution of the cycle-averaged local heat transfer coefficient obtained by the numerical simulation is found to be in good consistence with the test result. Due to the existence of the heated surface, the vortical structures excited by the piezoelectric fan behave somewhat differently from those observed in the free space. The shedding vortex is easier to be broken down in relation to the case in the free space. The near-wall flow field induced by the piezoelectric fan demonstrates obvious lateral flow parallel to the fan, and suction flow on both sides of the fan. The local convective heat transfer in the fan-tip vibration envelope is effectively enhanced. Dumbbell-shaped distribution of local convective heat transfer around the fan-tip vibration envelope is demonstrated.

Key words: piezoelectric fan, convective heat transfer, numerical simulation, vibration test, heat transfer coefficient

CLC Number:

O354
V231.11

LI Xinjun, ZHANG Jingzhou, TAN Xiaoming. Characteristics of heat transfer with single piezoelectric fan[J]. ACTA AERONAUTICAET ASTRONAUTICA SINICA, 2017, 38(7): 120982-120982.

References

[1] YOO J H, HONG J I, CAO W. Piezoelectric ceramic bimorph coupled to thin metal plate as cooling fan for electronic devices[J]. Sensors Actuators A, 2000, 79(1): 8-12.
[2] WU T, RO P I, KINGON A I, et al. Piezoelectric resonating structures for microelectronic cooling[J]. Smart Materials and Structures, 2003, 12(2): 181-187.
[3] GILSON G M, PICKERING S J, HANN D B, et al. Piezoelectric fan cooling: A novel high reliability electric machine thermal management solution[J]. IEEE Transactions on Industrial Electronics, 2013, 60(11): 4841-4851.
[4] TODA M. Theory of air flow generation by a resonant type PVF2 bimorph cantilever vibrator[J]. Ferroelectrics, 1979, 22(3): 911-918.
[5] SYDNEY M W, BASAK S, GARIMELLA S V, et al. Piezoelectric fans using higher flexural models for electronics cooling applications[J]. IEEE Transactions on Components and Packaging Technologies, 2007, 30(1): 119-128.
[6] KIM Y H, WERELEY S T, CHUN C H. Phase-resolved flow field produced by a vibrating cantilever plate between two endplates[J]. Physics in Fluids, 2004, 16(1): 145-162.
[7] KIM Y H, CHUN C H, WERELEY S. Flow field around a vibrating cantilever: Coherent structure education by continuous wavelet transform and proper orthogonal decomposition[J]. Journal of Fluid Mechanics, 2011, 669: 584-606.
[8] CHOI M, CIERPKA C, KIM Y H. Vortex formation by a vibrating cantilever[J]. Journal of Fluids and Structures, 2012, 31: 67-78.
[9] ACIKLAIN T, WAIT S M, GARIMELLA S V. Experimental investigation of the thermal performance of piezoelectric fans[J]. Heat Transfer Engineering, 2004, 25(1): 4-14.
[10] KIMBER M, GARIMELLA S V, RAMAN A. Local heat transfer coefficients induced by piezoelectrically actuated vibrating cantilevers[J]. ASME Journal of Heat Transfer, 2007, 129(9): 1168-1176.
[11] KIMBER M, GARIMELLA S V. Measurement and prediction of the cooling characteristics of a generalized vibrating piezoelectric fan[J]. International Journal of Heat and Mass Transfer, 2009, 52(19-20): 4470-4478.
[12] KIMBER M, GARIMELLA S V. Cooling performance of arrays of vibrating cantilevers[J]. ASME Journal of Heat Transfer, 2009, 131(11): 111401-1-8.
[13] LIU S F, HUANG R T, SHEU W J, et al. Heat transfer by a piezoelectric fan on a flat surface subject to the influence of horizontal/vertical arrangement[J]. International Journal of Heat and Mass Transfer, 2009, 52(11-12): 2565-2570.
[14] FAIRUZ Z M, SUFIAN S F, ABDULLAH M Z, et al. Effect of piezoelectric fan mode shape on the heat transfer characteristics[J]. International Communications in Heat and Mass Transfer, 2014, 52: 140-151.
[15] 谭蕾, 谭晓茗, 张靖周. 压电风扇激励非定常流动和换热特性数值研究[J]. 航空学报, 2013, 34(6): 1277-1284. TAN L, TAN X M, ZHANG J Z. Numerical investigation on unsteady flow and heat transfer characteristics of piezoelectric fan[J]. Acta Aeronautica et Astronautica Sinica, 2013, 34(6): 1277-1284 (in Chinese).
[16] TAN L, ZHANG J Z, TAN X M. Numerical investigation of convective heat transfer on a vertical surface due to resonating cantilever beam[J]. International Journal of Thermal Sciences, 2014, 80: 93-107.
[17] 孔岳, 李敏, 吴蒙蒙. 压电风扇非定常流场速度分布的数值研究[J]. 工程力学, 2016, 33(1): 209-216. KONG Y, LI M, WU M M. Numerical investigation on the velocity of unsteady flow field induced by piezoelectric fan[J]. Engineering Mechanics, 2016, 33(1): 209-216 (in Chinese).
[18] BREVET P, DEJEU C, DORIGNAC E, et al. Heat transfer to a row of impinging jets in consideration of optimization[J]. International Journal of Heat and Mass Transfer, 2002, 45(20): 4191-4200.
[19] MOFFAT R J. Describing the uncertainties in experimental results[J]. Experimental Thermal and Fluid Science, 1998, 1(1): 3-17.
[20] LIN C N. Enhanced heat transfer performance of cylindrical surface by piezoelectric fan under forced convection conditions[J]. International Journal of Heat and Mass Transfer, 2013, 60: 296-308.
[21] JEONG J, HUSSAIN F. On the definition of a vortex[J]. Journal of Fluid Mechanics, 1995, 285(1): 69-94.

Characteristics of heat transfer with single piezoelectric fan

PDF (PC)

Knowledge

Abstract

Cite this article

share this article

References

Related Articles 15

Recommended Articles

Metrics

Comments

[1]	Fanmin MENG, Nuo MA, Wenchao MA, Junhui MENG, Wenguang LI. Wet modal analysis and tests for inflatable wing with swept air-beams [J]. ACTA AERONAUTICAET ASTRONAUTICA SINICA, 2023, 44(2): 227098-227098.
[2]	Mei ZHENG, Lijuan FENG, Na QIN, Jinge YIN. 3D computational method for conjugate heat transfer between internal and external flow of nacelle anti-icing system [J]. ACTA AERONAUTICAET ASTRONAUTICA SINICA, 2023, 44(1): 627425-627425.
[3]	XIAHOU Tangfan, CHEN Jiangtao, SHAO Zhidong, WU Xiaojun, LIU Yu. Model validation metrics for CFD numerical simulation under aleatory and epistemic uncertainty [J]. ACTA AERONAUTICAET ASTRONAUTICA SINICA, 2022, 43(8): 25716-025716.
[4]	YANG Jiankai, GU Dongdong, GE Qing, TAN Chenchen, WEN Yu. Support layout and precise forming mechanism of aluminum alloy for laser additive manufacturing [J]. ACTA AERONAUTICAET ASTRONAUTICA SINICA, 2022, 43(4): 525331-525331.
[5]	JIANG Youxu, LI Jie, YANG Zhao. Data correction method of wind tunnel test for verification aircraft with laminar wing section [J]. ACTA AERONAUTICAET ASTRONAUTICA SINICA, 2022, 43(11): 526814-526814.
[6]	WANG Hao, ZHONG Min, HUA Jun, ZHONG Hai, YANG Tihao, WANG Meng, LEI Guodong. Simulation and experiment of natural laminar flow flight test wing glove [J]. ACTA AERONAUTICAET ASTRONAUTICA SINICA, 2022, 43(11): 526785-526785.
[7]	DUAN Junyi, TONG Fulin, LI Xinliang, LIU Hongwei. Decomposition of mean friction drag in compression-expansion turbulent boundary layer [J]. ACTA AERONAUTICAET ASTRONAUTICA SINICA, 2022, 43(1): 625915-625915.
[8]	SHEN Pengfei, LIU Pengxin, SUN Dong, YUAN Xianxu. Statistical characteristics of skin friction of shock wave/turbulent boundary layer interaction in hollow cylinder-flare configuration at Mach 6 [J]. ACTA AERONAUTICAET ASTRONAUTICA SINICA, 2022, 43(1): 626005-626005.
[9]	LIU Pengxin, YUAN Xianxu, LIANG Fei, LI Chen, SUN Dong. Quadrant decomposition analysis of fluctuations in high-temperature turbulent boundary layer with chemical non-equilibrium [J]. ACTA AERONAUTICAET ASTRONAUTICA SINICA, 2021, 42(S1): 726338-726338.
[10]	BAO Jun, WANG Yu, NIU Qian, ZHU Xidong, CHENG Jianjie. Influencing parameters and film flow mechanism of spray droplet impacting liquid film [J]. ACTA AERONAUTICAET ASTRONAUTICA SINICA, 2021, 42(S1): 726360-726360.
[11]	CHEN Chongpei, LIANG Jianhan, GUAN Qingdi, GAO Tianyun. Conservative compressible one-dimensional turbulence method and its application in supersonic scalar mixing layer [J]. ACTA AERONAUTICAET ASTRONAUTICA SINICA, 2021, 42(S1): 726364-726364.
[12]	LI Qing, TU Guohua, YU Zhaosheng, LIN Zhaowu, LI Tingting, YUAN Xianxu. Inertial particle transport in non-uniform accelerated flow [J]. ACTA AERONAUTICAET ASTRONAUTICA SINICA, 2021, 42(S1): 726390-726390.
[13]	LI Chengcheng, LI Fang, YANG Bin, WANG Ying. Numerical investigation of nozzle flow separation control using plasma actuation [J]. ACTA AERONAUTICAET ASTRONAUTICA SINICA, 2021, 42(7): 124547-124547.
[14]	LYU Yuanwei, ZHANG Jingzhou, SHAN Yong, SUN Wenjing. Convective heat transfer of chevron-nozzle jet impingement on semi-circular surfaces [J]. ACTA AERONAUTICAET ASTRONAUTICA SINICA, 2021, 42(7): 124762-124762.
[15]	HE Chuangxin, DENG Zhiwen, LIU Yingzheng. Turbulent flow data assimilation and its applications [J]. ACTA AERONAUTICAET ASTRONAUTICA SINICA, 2021, 42(4): 524704-524704.