接触热阻对疏导式热防护结构防热效果的影响

固体力学与飞行器总体设计

本期目录 | 过刊浏览 | 高级检索

前一篇 | 后一篇

接触热阻对疏导式热防护结构防热效果的影响

刘冬欢, 尚新春

北京科技大学数理学院应用力学系, 北京 100083

收稿日期:2011-11-16 修回日期:2011-12-27 出版日期:2012-10-25 发布日期:2012-10-25
通讯作者: 刘冬欢 E-mail:liudh@ustb.edu.cn
基金资助:
国家自然科学基金(10872104, 10772024);中央高校基本科研业务费专项资金(FRF-BR-10-007A, FRF-AS-09-001A)

Effect of Thermal Contact Resistance on the Performance of Heat-pipe-cooled Thermal Protection Structures

LIU Donghuan, SHANG Xinchun

Department of Applied Mechanics, School of Mathematics and Physics, University of Science and Technology Beijing, Beijing 100083, China

Received:2011-11-16 Revised:2011-12-27 Online:2012-10-25 Published:2012-10-25
Supported by:
National Natural Science Foundation of China (10872104, 10772024); The Fundamental Research Funds for the Central Universities (FRF-BR-10-007A, FRF-AS-09-001A).

摘要/Abstract

摘要： 采用内置高温热管的疏导式热防护结构是一种新型高效的热防护方式,热管与高温复合材料之间的接触热阻(TCR)对防热效果有重大的影响。首先给出了一种疏导式热防护结构的计算模型,进而采用间接耦合的方法建立了由接触热阻引起的热力耦合问题的计算格式,在此基础上对不同预留间隙条件下的热防护结构进行了热力耦合分析,重点考察了接触热阻对其防热效果的影响。研究结果表明,采用预留装配间隙的方法可以有效降低结构的应力水平,但同时使得界面接触热阻增加,从而使得结构驻点温度升高,因此在采用预留间隙设计时必须在考虑界面接触热阻的条件下从结构强度和温度两方面对结构进行安全性评估。

关键词: 疏导式热防护, 接触热阻, 高温热管, 热力耦合, 预留间隙

Abstract: Heat-pipe-cooled leading edge structure is a novel and efficient thermal protection method, and the thermal contact resistance(TCR) between the heat pipe and high temperature composite material strongly influences the thermal protection performance of the whole structure. A computational model of the heat-pipe-cooled thermal protection structure is first constructed, and then the computational scheme of the thermomechanical coupling caused by thermal contact resistance is established based on the sequential coupling method. The thermomechanical coupling analysis of the thermal protection structure under different initial gaps are then performed based on the present method, with emphasis on the influence of thermal contact resistance on the thermal protection effect. Numerical results show that using the initial gap can greatly reduce the stress level of the structure, while the interface thermal contact resistance and stagnation temperature increase. In the structural safety evaluation of heat-pipe-cooled thermal protection structures, both the stress criterion and temperature criterion must be satisfied at the same time.

Key words: heat-pipe-cooled thermal protection, thermal contact resistance, high temperature heat pipe, thermomechanical coupling, initial gap

中图分类号:

V414.9

刘冬欢, 尚新春. 接触热阻对疏导式热防护结构防热效果的影响[J]. 航空学报, 2012, 33(10): 1834-1841.

LIU Donghuan, SHANG Xinchun. Effect of Thermal Contact Resistance on the Performance of Heat-pipe-cooled Thermal Protection Structures[J]. ACTA AERONAUTICAET ASTRONAUTICA SINICA, 2012, 33(10): 1834-1841.

参考文献

[1] Liu D H, Zheng X P, Wang F, et al. Heat conduction and heat proof mechanism of the heat pipe cooled thermal protection system. Journal of Tsinghua University, 2010, 50(7): 1094-1098. (in Chinese) 刘冬欢, 郑小平, 王飞, 等. 内置高温热管热防护结构传热防热机理研究. 清华大学学报, 2010, 50(7): 1094-1098.
[2] Silverstein C C. A feasibility study of heat pipe cooled leading edges for hypersonic cruise aircraft. NASA CR-1857, 1971.
[3] Niblock G, Reeder J, Huneidi F. Four space shuttle wing leading edge concepts. Journal of Spacecraft, 1974, 11(5): 314-320.
[4] Anon. Study of structural active cooling and heat sink systems for space shuttle. NASA CR-123912, 1972.
[5] Camarda C J, Masek R V. Design, analysis and tests of a shuttle-type heat-pipe-cooled leading edge. Journal of Spacecraft and Rockets, 1981, 18(1): 71-78.
[6] Jang J. An analysis of startup from the frozen state and transient performance of heat pipes. Atlanta: School of Engineering, Georgia Institute of Technology, 1988.
[7] Wojcik C C, Clark L T. Design, analysis, and testing of refractory metal heat pipe using lithium as the working fluid. AIAA-1991-1400, 1991.
[8] Rovang R D, Juhasz A J. Carbon-carbon heat pipe testing and evaluation. AIAA-1994-4065, 1994.
[9] Glass D E, Camarda C J, Merrigan M A, et al. Fabrication and testing of Mo-Re heat pipes embedded in carbon/carbon. Journal of Spacecraft and Rockets, 1999, 36(1): 79-86.
[10] Steeves C A, He M Y, Kasen S D, et al. Feasibility of metallic structural heat pipes as sharp leading edges for hypersonic vehicles. Journal of Applied Mechanics, 2009, 76(3): 1-9.
[11] Bai T, Zhang H, Xu H. Application of high temperature heat pipe in hypersonic vehicles thermal protection. Journal of Central South University of Technology, 2011, 18(4): 1278-1284.
[12] Sun J, Liu W Q. Analysis of sharp leading-edge thermal protection of high thermal conductivity materials. Acta Aeronautica et Astronautica Sinica, 2011, 32(9): 1622-1628. (in Chinese). 孙健, 刘伟强. 尖化前缘高导热材料防热分析. 航空学报, 2011, 32(9): 1622-1628.
[13] Chen L Z, Ou D B, Liu D Y. Elementary experiment study on the application of high temperature heat-pipe to the thermal protection. Frontier Science, 2009, 3(10): 41-45. (in Chinese). 陈连忠, 欧东斌, 刘德英. 高温热管在热防护中应用初探. 前沿科学, 2009, 3(10): 41-45.
[14] Liu D H, Zheng X P, Wang F, et al. Mechanism of thermomechanical coupling of high temperature heat pipe cooled C/C composite material thermal protection structure. Acta Materiea Compositae Sinica, 2010, 27(3): 43-49. (in Chinese). 刘冬欢, 郑小平, 王飞, 等. 内置高温热管C/C复合材料热防护结构热力耦合机制. 复合材料学报, 2010, 27(3): 43-49.
[15] Liu D H, Zheng X P, Huang Q Z, et al. Experimental investigation of high-temperature thermal contact resistance between C/C composite material and superalloy GH600. Acta Aeronautica et Astronautica Sinica, 2010, 31(11): 2189-2194. (in Chinese). 刘冬欢, 郑小平, 黄拳章, 等. C/C复合材料与高温合金GH600之间高温接触热阻的试验研究. 航空学报, 2010, 31(11): 2189-2194.
[16] Liu D H, Zheng X P. Verification and experimental investigation of thermal contact resistance in heat-pipe-cooled thermal protection structures. Research Report of Tsinghua University, 2010. (in Chinese). 刘冬欢, 郑小平. 疏导式热防护结构接触热阻验证分析与实验报告. 清华大学科研报告, 2010.

E-mail：hkxb@buaa.edu.cn

关于我们

期刊社服务

专业学科

封面文章

友情链接

主管单位：中国科学技术协会主办单位：中国航空学会北京航空航天大学

接触热阻对疏导式热防护结构防热效果的影响

Effect of Thermal Contact Resistance on the Performance of Heat-pipe-cooled Thermal Protection Structures

PDF (PC)

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 9

编辑推荐

Metrics

本文评价

[1]	马玉娥, 杨萌, 孙文博. 基于近场动力学理论的热障涂层热冲击开裂行为[J]. 航空学报, 2022, 43(6): 526587-526587.
[2]	艾邦成, 陈思员, 韩海涛, 胡龙飞, 鲁芹, 初敏, 邓代英, 俞继军. 疏导式热防护结构传热极限特性[J]. 航空学报, 2021, 42(2): 623989-623989.
[3]	周霞, 文冬, 沈梦祺, 宋尚雨. AZ31镁合金板热成形中的屈服和损伤:本构实现与数值分析[J]. 航空学报, 2018, 39(5): 421665-421665.
[4]	牛涛, 张艳苓, 侯红亮, 王耀奇, 何铎. 高温热管性能分析与试验[J]. 航空学报, 2016, 37(S1): 59-65.
[5]	郭良刚, 陈建华, 杨合, 谷瑞杰. TC4钛合金锥形环热辗轧应变及温度场对轧辊尺寸的响应规律[J]. 航空学报, 2013, 34(6): 1463-1473.
[6]	孙健, 刘伟强. 尖化前缘高导热材料防热分析[J]. 航空学报, 2011, 32(9): 1622-1628.
[7]	王宗仁, 张卫方, 唐庆云, 刘升旺. 带补偿加热的GH4169间的接触热导测试研究[J]. 航空学报, 2011, 32(10): 1945-1950.
[8]	刘冬欢;郑小平;黄拳章;姚福印;刘应护. C/C复合材料与高温合金GH600之间高温接触热阻的试验研究[J]. 航空学报, 2010, 31(11): 2189-2194.
[9]	黄志刚;柯映林;王立涛. 金属切削加工的热力耦合模型及有限元模拟研究[J]. 航空学报, 2004, 25(3): 317-320.