航空学报 > 1985, Vol. 6 Issue (4): 335-343

用“O”型胶圈支撑的空气静压轴承稳定性研究

尹佩琪   

  1. 中国航空附件研究所
  • 收稿日期:1984-04-04 修回日期:1900-01-01 出版日期:1985-08-25 发布日期:1985-08-25

A STUDY ON STABILITY OF AN EXTERNALLY PRESSURIZED GAS JOURNAL BEARING WITH "0" RUBBER SUPPORT

Yin Peiqi   

  1. Institute of Aero-Accessories
  • Received:1984-04-04 Revised:1900-01-01 Online:1985-08-25 Published:1985-08-25

摘要: 本文从工程应用的角度出发,提供了一种估算“○”型胶圈支撑空气轴承失稳速度的简化理论计算方法。轴承结构参数对胶圈抑制涡动的能力有影响,通过试验得出了一些重要结论。

Abstract: A simplified formula for estimating the instability threshold of aerostatic journal bearing system supported elastically by means of O-rings are derived. Also, experimental investigation has been carried out to estimate the instability threshold. The obtained data of the critical rotation frequency at the instability threshold are given in Fig. 3. The results calculated by the formula are compared with the experimental data graphically.The effects of supply pressures from 196.1kPa to 686.5kPa and of radial clearances from 0.02mm to 0.06mm for three kinds of rubber are investigated and therefrom the following conclusions are drawn:(1) The instability threshold falls with increasing he rubber hardness for the bearing with large clearance at low supply pressures. It is shown that the soft rubber is superior to the hard one in the above-mentioned case.(2) For each rubber tested there exists an optimum bearing clearance. Its threshold of whirl instability is the highest. Moreover, It is much higher than that of the rigidly supported bearing.