Experimental Investigations

Test of unsteady flow in the tip clearance of low speed axial flow compressor

  • GAO Limin ,
  • LI Yongzeng ,
  • LIU Xiaodong ,
  • ZHANG Shuai
Expand
  • 1. School of Power and Energy, Northwestern Polytechnical University, Xi'an 710072, China;
    2. Collaborative Innovation Center of Advanced Aero-Engine, Beijing 100083, China

Received date: 2016-01-14

  Revised date: 2016-02-17

  Online published: 2016-04-11

Supported by

National Natural Science Foundation of China (51236006, 51476132)

Abstract

The flow field in the blade tip clearance of a low-speed axial compressor rotor is measured in detail using high frequency dynamic pressure sensors. The study of the development of the unsteady flow in tip leakage when the compressor throttles to stall has been carried out by analyzing the signal characteristic. The results show that there is a stall cell in the tip clearance and it rotates along the circumferential direction by 46.5% of rotor speed when the rotor gets stalled. When the compressor throttles, a characteristic frequency band appears and it changes according to the energy transformation of unsteady pressure fluctuations in the leading edge of the blade tip. With the flow mass decreasing, tip leakage flow moves forward to the leading edge. A stall cell arises near the leading edge and extends to the trailing edge, eventually covers the whole blade chord length; under the condition of being near stall, low pressure areas in the tip clearance exhibit a "front-back" alternative distribution in channels due to the interaction of the tip leakage flow in adjacent channels. Finally, a disturbance wave forms in the circumferential direction, and its scale is about two blade channels.

Cite this article

GAO Limin , LI Yongzeng , LIU Xiaodong , ZHANG Shuai . Test of unsteady flow in the tip clearance of low speed axial flow compressor[J]. ACTA AERONAUTICAET ASTRONAUTICA SINICA, 2016 , 37(8) : 2614 -2622 . DOI: 10.7527/S1000-6893.2016.0099

References

[1] 童志庭. 轴流压气机中叶尖泄漏涡、失速先兆、叶尖微喷气非定常关联性的实验研究[D]. 北京:中国科学院, 2006. TONG Z T. The interactive unsteady mechanism between tip leakage vortex,stall inception and micro tip injection in low-speed axial compressor[D]. Beijing:Chinese Academy of Sciences, 2006(in Chinese).
[2] 卢新根. 轴流压气机内部流动失稳及其被动控制策略研究[D]. 西安:西北工业大学, 2007. LU X G. Research on internal flow instability and passive control strategy of axial flow compressor[D]. Xi'an:Northwestern Polytechnical University, 2007(in Chinese).
[3] VO H D, TAN C S, GREITZER E M, et al. Criteria for spike initiated rotating stall[J]. Journal of Turbomachinery, 2008, 130(1):155-165.
[4] BAGHDADI S. Modeling tip clearance effects in multistage axial compressors[J]. Journal of Turbomachinery, 1996, 118(4):697-705.
[5] SCHLECHTRIEM S, LOTZERICH M. Breakdown of tip leakage vortices in compressors at flow conditions close to stall:ASME-GT97-41[R]. New York:ASME, 1997.
[6] JIN W B, BREUER K S, TAN C S. Active control of tip clearance flow in axial compressors[J]. Journal of Turbomachinery, 2003, 127(2):531-542.
[7] 邓向阳, 张宏武, 朱俊强,等. 压气机非定常叶顶间隙流的数值模拟研究[J]. 工程热物理学报, 2006, 27(2):229-231. DENG X Y, ZHANG H W, ZHU J Q, et al. Investigation on unsteady tip clearance flow in a compressor by numerical simulations[J]. Journal of Engineering Thermophysics, 2006, 27(2):229-231(in Chinese).
[8] MAILACH R, SAUER H, VOGELER K. The periodical interaction of the tip clearance flow in the blade rows of axial compressors:ASME-GT2001-0299[R]. New York:ASME, 2001.
[9] MAILACH R, LEHMANN I, VOGELER K. Rotating instabilities in an axial compressor originating from the fluctuating blade tip vortex[J]. Journal of Turbomachinery, 2001, 123(3):453-460.
[10] YAMADA K, FUNAZAKI K, FURUKAWA M. The behavior of tip clearance flow at near-stall condition in a transonic axial compressor rotor:ASME-GT2007-27725[R]. New York:ASME, 2007.
[11] 吴艳辉, 李清鹏, 张卓勋, 等. 轴流压气机转子近失速工况点叶尖区流动非定常性分析[J]. 推进技术, 2010, 31(5):562-566. WU Y H, LI Q P, ZHANG Z X, et al. Unsteady behavior of tip clearance now in an axial now compressor rotor at near stall condition[J]. Journal of Propulsion Technology, 2010, 31(5):562-566(in Chinese).
[12] 吴艳辉, 吴俊峰, 稂仿玉, 等. 轴流压气机转子近叶尖流动的试验和数值研究之二:近失速工况流动特征分析[J]. 工程热物理学报, 2014, 35(1):60-65. WU Y H, WU J F, LANG F Y, et al. Experimental and numerical investigation of near-tip flow-field in an axial flow compressor rotor:Part Ⅱ:Flow characteristics at near-stall operating conditions[J]. Journal of Engineering Thermophysics, 2014, 35(1):60-65(in Chinese).
[13] FURUKAWA M, SAIKI K, YAMADA K, et al. Anomalous flow phenomena due to breakdown of tip leakage vortex in an axial compressor rotor at near-stall condition[J]. Nihon Kikai Gakkai Ronbunshu B Hen/Transactions of the Japan Society of Mechanical Engineers Part B, 2000, 66(644):1029-1037.
[14] VALKOV T V, TAN C S. Effect of upstream rotor vortical disturbances on the time-averaged performance of axial compressor stators:Part I:Framework of technical approach and wake-stator blade interactions[J]. Journal of Turbomachinery, 1999, 121(3):377-386.
[15] VALKOV T V, TAN C S. Effect of upstream rotor vortical disturbances on the time-averaged performance of axial compressor stators. Part Ⅱ:Rotor tip vortex/streamwise vortex-stator blade interactions[J]. Journal of Turbomachinery, 1999, 121(3):387-397.
[16] CHEN J P, HATHAWAY M D, HERRICK G P. Prestall behavior of a transonic axial compressor stage via time-accurate numerical simulation[J]. Journal of Turbomachinery, 2008, 130(4):353-368.
[17] HAH C, BERGNER J, SCHIFFER HP. Short length-scale rotating stall inception in a transonic axial compressor:Experimental investigation:ASME-GT2006-90209[R]. New York:ASME, 2006:131-140.
[18] HAH C, BERGNER J, SCHIFFER HP. Short length-scale rotating stall inception in a transonic axial compressor:Criteria and mechanisms:ASME-GT2006-90045[R]. New York:ASME, 2006.
[19] CAMP T R, DAY I J. A study of spike and modal stall phenomena in a low-speed axial compressor[J]. Journal of Turbomachinery, 1998, 120(3):393-401.
[20] MAILACH R, LEHMANN I, VOGELER K. Rotating instabilities in an axial compressor originating from the fluctuating blade tip vortex[J]. Journal of Turbomachinery, 2001, 123(3):453-460.

Outlines

/