吸气式高超声速飞行器非均匀尾喷流试验
收稿日期: 2016-03-08
修回日期: 2016-08-29
网络出版日期: 2017-04-11
Test of non-uniform nozzle plume for air-breathing hypersonic vehicle
Received date: 2016-03-08
Revised date: 2016-08-29
Online published: 2017-04-11
在中国空气动力研究与发展中心ø0.5 m高超声速风洞中，开展了非均匀喷流条件下的吸气式高超声速飞行器后体尾喷流/外流干扰测压试验研究。采用非均匀内喷管，模拟飞行器尾喷管非均匀入流，测量了飞行器后体膨胀面及水平翼表面压力，采用高清纹影观测了喷流干扰区域的流场结构，获得了不同工况下非均匀入流对尾部及水平翼表面压力分布的影响规律。试验结果显示尾喷管非均匀入流对飞行器尾部壁面压力分布及流场结构有明显影响，喷管入流的非均匀特征在吸气式高超声速飞行器喷流模拟中不可忽视。非均匀喷流核心区压力分布明显高于均匀喷流时的结果；核心区域外，非均匀喷流的作用面积略小于均匀喷流，且非均匀喷流同外流交叉干扰区域的面积和强度要略小于均匀喷流；均匀喷流在喷管出口区域存在明显的膨胀波系，交叉干扰激波及剪切层的扩张角也大于非均匀入口条件时的结果。
贺旭照 , 秦思 , 卫锋 , 乐嘉陵 . 吸气式高超声速飞行器非均匀尾喷流试验[J]. 航空学报, 2017 , 38(3) : 120199 -120199 . DOI: 10.7527/S1000-6893.2016.0246
The pressure test for the inner-outer flow interaction area are conducted at the 0.5 m hypersonic wind tunnel in China Aerodynamics Research and Development Center. The test are conducted at the conditions of uniform and non-uniform incoming flow. Using non-uniform inner nozzle, the pressure on the afterbody expansion surface and the horizontal wing surface of the aircraft can be measured by simulating the non-uniform incoming flow of the aircraft nozzle. High speed schlieren is used to observe the flow field structure of the interaction areas of the plume, and the rules of influence of non-uniform incoming flow on pressure distribution on the afterbody expansion surface and horizontal surface of the aircraft nozzle can be got under different conditions. The test results show that the non-uniform incoming flow of the nozzle has significant influence on wall surface pressure distribution and flow field structure of the aircraft. The non-uniform characteristic of the nozzle's incoming flow cannot be ignored in simulation of air breathing hypersonic vehicle plume. It can be seen from the test result that the pressure of the non-uniform plume's core area is obviously higher than that of the uniform plume; while outside the core area, the non-uniform plume has a slightly smaller action area than the uniform plume, and the interaction area and intensity of non-uniform plume and outflow is also smaller than those of uniform plume. The uniform plume has distinct expansion waves in the exit area of the nozzle, and the expansion angles of interaction shock wave and shear layer of the uniform plume are larger than those of the non-uniform plume.
[1] EBRANHIMI H B, LANKFORD D W. Numerical study of phenomena affecting the prediction fo scramjet combustor and nozzle performance:AIAA-1993-0024[R]. Reston:AIAA, 1993.
[2] SPAID F W, KEENER E R. Experimental results for a hypersonic nozzle/afterbody flow field:AIAA-1992-3915[R]. Reston:AIAA, 1992.
[3] RUFFIN S M, VENKATAPATHY E. Single expansion ramp nozzle simulation:AIAA-1992-0387[R]. Reston:AIAA, 1992.
[4] TATUM K, MONTA W, WITTE D, et al. Analysis of generic scramjet external nozzle flowfields employing simulant gases:AIAA-1990-5242[R]. Reston:AIAA, 1990.
[5] WATANABE S. Scramjet nozzle experiment with hypersonic external flow[J]. Journal of Propulsion and Power, 1993, 9(4):521-528.
[6] MITANI T, UEDA S. Validation studies of scramjet nozzle performance[J]. Journal of Propulsion and Power, 1993, 9(5):725-730.
[7] HIRAIWA T, TOMIOKA S, UDEA S, et al. Performance variation of scramjet nozzle at various nozzle pressure ratios[J]. Journal of Propulsion and Power, 1995, 11(3):403-408.
[8] MITANI T, TANI K, SATO S, et al. Experimental validation of scramjet nozzle performance:AIAA-1992-3290[R]. Reston:AIAA, 1992.
[9] HIRSCHEN C, GRUHN P, GVLHAN A. Influence of heat capacity ratio on the interaction between the external flow and nozzle flow of a scramjet:AIAA-2006-8095[R]. Reston:AIAA, 2006.
[10] HIRSCHEN C, GVLHAN A. Influence of heat capacity ratio on pressure and nozzle flow of scramjets[J]. Journal of Propulsion and Power, 2009, 25(2):303-311.
[11] HIRSCHEN C, GVLHAN A, BECK W H, et al. Measurement of flow properties and thrust on scramjet nozzle using pressure-sensitive paint[J]. Journal of Propulsion and Power, 2009, 25(2):267-280.
[12] HIRSCHEN C. Experimental study of the interaction between internal and external flows of a scramjet nozzle using various diagnostic techniques:AIAA-2007-5088[R]. Reston:AIAA, 2007.
[13] HIRSCHEN C, GVLHAN A, BECK W H, et al. Experimental study of a scramjet nozzle flow using the pressure-sensitive-paint method[J]. Journal of Propulsion and Power, 2008, 24(4):662-672.
[14] HIRSCHEN C, GVLHAN A. Infrared thermography and pitot pressure measurements of a scramjet nozzle flowfield[J]. Journal of Propulsion and Power, 2009, 25(5):1108-1120.
[15] 李斌, 王学占, 刘仙名. 大迎角侧向多喷干扰流场特性数值模拟[J]. 航空学报, 2015, 36(9):2828-2839. LI B, WANG X Z, LIU X M. Numerical investigation of multi-lateral jets interactions flow characteristics at high angle of attack[J]. Acta Aeronautica et Astronautica Sinica, 2015, 36(9):2828-2839(in Chinese).
[16] 贺旭照, 秦思, 曾学军, 等. 模拟飞行条件下的吸气式高超声速飞行器后体尾喷流干扰问题试验方案研究[J]. 推进技术, 2014, 35(10):1310-1316. HE X Z, QIN S, ZENG X J, et al. Experiment scheme research on afterbody nozzle plume interferenece of air-breathing hypersonic vehicle fly condition[J]. Journal of Propulsion Technology, 2014, 35(10):1310-1316(in Chinese).
[17] 李周复. 风洞特种试验技术[M]. 北京:航空工业出版社, 2010:37-50. LI Z F. Special wind tunnel experiment technology[M]. Beijing:Aviation Industry Press, 2010:37-50(in Chinese).
[18] ZUCROW M J, HOFFMAN J D. Gas dynamics[M]. New York:John Wiley and Sons, Inc., 1977:112-266.
[19] 贺旭照, 赵慧勇, 乐嘉陵. 考虑可压缩与热传导的壁面函数边界条件及其应用[J]. 空气动力学学报, 2006, 24(4):450-453. HE X Z, ZHAO H Y, LE J L. Application of wall function boundary condition considering heat transfer and compressibility[J]. Acta Aerodynamic Sinica, 2006, 24(4):450-453(in Chinese).
[20] 贺旭照. 高超声速飞行器气动力气动热数值模拟和超声速流动的区域推进求解[D]. 绵阳:中国空气动力研究与发展中心, 2007. HE X Z. Numerically simulate aero-force & heat of hypersonic vehicles and region marching method for supersonic flow simulation[D]. Mianyang:China Aerodynamics Research and Development Center, 2007(in Chinese).
/
| 〈 |
|
〉 |
CJA