一种改善高超声速进气道自起动能力的流场控制研究
收稿日期: 2014-04-18
修回日期: 2014-06-23
网络出版日期: 2014-09-16
基金资助
国家自然科学基金 (11302101);南京航空航天大学研究生创新基地(实验室)开放基金(kfjj20130203);中央高校基本科研业务费专项资金
A flow-control conception of improving self-start performance of hypersonic inlet
Received date: 2014-04-18
Revised date: 2014-06-23
Online published: 2014-09-16
Supported by
National Natural Science Foundation of China (11302101); the Foundation of Graduate Innovation Center in NUAA (kfjj20130203); the Fundamental Research Funds for the Central Universities
为了改善高超声速进气道在低马赫数下的自起动能力,提出了一种在进气道内利用不起动时诱导激波前后静压差开设回流通道的流场控制概念,对其改善流场特性的机理及回流通道典型几何参数对进气道流场特性和气动性能的影响进行了分析,获得了回流通道典型几何参数对进气道自起动性能的影响规律,并与原型面进气道性能进行对比分析。结果表明:回流通道使进气道自起动马赫数由Ma=4.7降低至Ma=3.6,进气道工作马赫数范围得到显著拓宽;回流通道进口位置对进气道自起动马赫数存在较大影响,但自起动马赫数几乎不随回流通道出口位置、回流通道宽度(b≥8 mm)而改变;在低马赫数时,回流通道对进气道不起动流场有明显改善。而高马赫数下回流通道对进气道性能几乎不产生影响,保证了高马赫数下进气道的性能。
王建勇 , 谢旅荣 , 赵昊 , 滕瑜琳 . 一种改善高超声速进气道自起动能力的流场控制研究[J]. 航空学报, 2015 , 36(5) : 1401 -1410 . DOI: 10.7527/S1000-6893.2014.0125
To improve the self-start performance of hypersonic inlet at low Mach number, a flow-control conception of backflow duct is put forward, which is driven by the pressure difference generated by the separation induced shock under unstart conditions. The influencing principles are analyzed, and the characteristics of inlet's flow field and the inlet's aerodynamic performances affected by variable geometry parameters of the backflow duct are investigated. Finally, compared with the primary inlet's performances, the results indicate that due to the backflow duct, the self-start Mach number is ascended from Ma=4.7 to Ma=3.6, expending the operating Mach range remarkably. The location of the backflow duct's entrance influences the self-start performance significantly, while the location of backflow duct's exit and the width of backflow duct's section (b≥8 mm)scarcely affectes the self-start ability. At low Mach number, the unstarted flow field of inlet is improved by the backflow duct considerably.But at high Mach number, the influence of backflow duct would be slight, satisfying the design performance requirements.
[1] Scharnhorst R K. An overview of military aircraft supersonic inlet aerodynamics[C]//50th AIAA Aerospace Sciences Meeting including the New Horizons Forum and Aerospace Exposition. Reston: AIAA, 2012.
[2] Ogawa H, Grainger A L, Boyce R R. Inlet starting of high-contraction axisymmetric scramjets[J]. Journal of Propulsion and Power, 2010, 26(6): 1247-1258.
[3] Do H, Im S, Mungal M G, et al. The influence of boundary layers on supersonic inlet unstart[C]//17th AIAA International Space Plane and Hypersonic Systems and Technologies Conference. Reston: AIAA, 2011.
[4] Falempin F, Wendling E, Goldfeld M, et al. Experimental investigation of starting process of a variable geometry air inlet operating from Mach 2 to Mach 8, AIAA-2006-4513[R]. Reston: AIAA, 2006.
[5] McClinton C. X-43: scramjet power breaks the hypersonic barrier[C]//44th AIAA Aerospace Sciences Meeting and Exhibit. Reston: AIAA, 2006.
[6] Huebner L D, Rock K E, Ruf E G, et al. Hyper-X flight engine ground testing for X-43 flight risk reduction, AIAA-2001-1809[R]. Reston: AIAA, 2001.
[7] Takayuki K, Nobuhiro T, Tetsuya S, et al. Development study on axisymmetric air inlet for ATREX engine, AIAA-2001-1985[R].Reston: AIAA, 2001.
[8] Jin Z G, Zhang K Y, Chen W M, et al. Design and regulating law of a two-dimensional variable geometry hypersonic inlet[J].Acta Aeronautica et Astronautica Sinica,2013, 34(4): 779-786 (in Chinese). 金志光, 张堃元, 陈卫明, 等. 高超声速二元变几何进气道气动方案设计与调节规律研究[J]. 航空学报, 2013, 34(4): 779-786.
[9] Wang W X, Yuan H C, Huang G P, et al. Impact of suction position on starting of hypersonic inlet[J]. Journal of Aerospace Power, 2009, 24(4): 919-924 (in Chinese). 王卫星, 袁化成, 黄国平, 等. 抽吸位置对高超声速进气道起动性能的影响[J]. 航空动力学报, 2009, 24(4): 919-924.
[10] Yan H M, Zhong J J, Han J A, et al. Research on boundary-layer suction in the throat of supersonic inlet[J]. Journal of Propulsion Technology, 2009, 30(2): 176-181 (in Chinese). 严红明, 钟兢军, 韩吉昂, 等. 超声速进气道喉道附面层抽吸[J]. 推进技术, 2009, 30(2): 176-181.
[11] Masud J. Effect of passive bleed system on an integrated elicitationerless supersonic inlet, AIAA-2011-0920[R]. Reston: AIAA, 2011.
[12] Häberle J, Gülhan A. Investigation of the performance of a scramjet inlet at Mach 6 with boundary layer bleed, AIAA-2006-8139[R]. Reston: AIAA, 2006.
[13] Herrmann D, Blem S, Gülhan A. Experimental study of boundary-layer bleed impact on ramjet inlet performance[J]. Journal of Propulsion and Power, 2011, 27(6): 1187-1195.
[14] Ma X F, Xie L R, Guo R W. Investigation of two-dimensional supersonic twin inlet with slot-coupled cavity in 90° configuration at venter[J]. Journal of Aerospace Power, 2010, 25(8): 1818-1824 (in Chinese). 麻肖妃, 谢旅荣, 郭荣伟. 双下侧布局带泄流腔二元进气道试验[J]. 航空动力学报, 2010, 25(8): 1818-1824.
[15] Yuan H C, Liang D W. Effect of suction on starting of hypersonic inlet[J]. Journal of Propulsion Technology, 2006, 27(6): 525-528 (in Chinese). 袁化成, 梁德旺. 抽吸对高超声速进气道起动能力的影响[J]. 推进技术, 2006, 27(6): 525-528.
[16] Tan H J, Chen Z, Li G S. A new concept and preliminary study of variable hypersonic inlet with fixed geometry based on shockwave[J]. Science in China, Series E, Technological Sciences, 2007, 37(11): 1469-1479 (in Chinese). 谭慧俊, 陈智, 李光胜. 基于激波形状控制的定几何高超声速可调进气道概念及初步验证[J]. 中国科学: E辑, 2007, 37(11): 1469-1479.
[17] Schülein E. Optical skin friction measurements in short-duration facilities[C]//The 24th AIAA Aerodynamic Measurement Technology and Ground Testing Conference. Reston: AIAA, 2004.
/
| 〈 |
|
〉 |
CJA