ACTA AERONAUTICAET ASTRONAUTICA SINICA >
Experimental investigation into adaptive Coanda jet control in highly loaded compressor
Received date: 2023-04-18
Revised date: 2023-05-12
Accepted date: 2023-06-07
Online published: 2023-06-16
Supported by
National Science and Technology Major Project(2017-II-0004-0017);Strategic Priority Research Program of the Chinese Academy of Sciences(XDA29050000)
Future development of aeroengines requires continuous increase in the compressor stage load， which will result in strong secondary flows such as corner separation and boundary layer flow separation in the compressor. In this paper， a new Adaptive Coanda Jet Control （ACJC） technology is proposed to intelligently and efficiently restrain the flow separation in the compressor and improve the diffusion capacity of the compressor， and the stable and efficient operation range of the highly loaded compressor is dramatically broadened. To construct the ACJC system and verify its control effect in a highly loaded compressor， we first employ a highly loaded compressor stator cascade constructed based on the Zierke & Deutsch airfoil to investigate the ACJC system， with the diffusion factor of 0.66 at the design point. Then， the variance analysis method， principal component analysis method and neural network algorithm are adopted to establish the incidence angle prediction model and the optimal injection mass flow rate prediction model of the Coanda jet flap. Finally， an experimental platform based on the ACJC system is built to verify the effectiveness and accuracy of flow separation control for the highly loaded cascade. The experimental results indicate that the ACJC system can accurately predict the incidence angle and adjust the Coanda jet mass flow rate in real time at different incidence angles and different incoming Mach numbers. In addition， compared to the cascade without the ACJC system at the incidence angel of 5°， the total pressure loss coefficient is reduced by 11.5%， 9.8% and 8.0% for incoming Mach numbers of 0.4， 0.5 and 0.6， respectively.
Jian ZHANG , Min ZHANG , Juan DU , Weiliang HUANG , Chaoqun NIE . Experimental investigation into adaptive Coanda jet control in highly loaded compressor[J]. ACTA AERONAUTICAET ASTRONAUTICA SINICA, 2023 , 44(22) : 128883 -128883 . DOI: 10.7527/S1000-6893.2023.28883
| 1 | ZHENG X Q， LI Z H. Blade-end treatment to improve the performance of axial compressors： An overview［J］. Progress in Aerospace Sciences， 2017， 88： 1-14. |
| 2 | LU H W， YANG Y， GUO S， et al. Control of corner separation via dimpled surface for a highly loaded compressor cascade under different inlet Mach number［J］. Aerospace Science and Technology， 2019， 85： 48-60. |
| 3 | 张健， 杜娟， 陈泽， 等. 高负荷压气机叶栅流动分离的主动控制方法综述［J］. 工程热物理学报， 2022， 43（5）： 1190-1202. |
| ZHANG J， DU J， CHEN Z， et al. Active flow control concepts of secondary flow on a highly loaded compressor cascade［J］. Journal of Engineering Thermophysics， 2022， 43（5）： 1190-1202 （in Chinese）. | |
| 4 | DU J， LI Y W， LI Z H， et al. Performance enhancement of industrial high loaded gas compressor using Coanda jet flap［J］. Energy， 2019， 172： 618-629. |
| 5 | PENDAR M R， PáSCOA J C. Numerical investigation of plasma actuator effects on flow control over a three-dimensional airfoil with a sinusoidal leading edge［J］. Journal of Fluids Engineering， 2022， 144（8）： 081208. |
| 6 | FIETZKE B， MIHALYOVICS J， KING R， et al. Binary repetitive model predictive active flow control applied to an annular compressor stator cascade with periodic disturbances［J］. Journal of Engineering for Gas Turbines and Power， 2022， 144（1）： 011029. |
| 7 | 张博涛， 刘波， 王何建. 端壁抽吸控制下攻角对压气机叶栅叶尖泄漏流动的影响［J］. 航空动力学报， 2020， 35（11）： 2400-2412. |
| ZHANG B T， LIU B， WANG H J. Impact of incidence angle on tip leakage flow control by endwall suction in a compressor cascade［J］. Journal of Aerospace Power， 2020， 35（11）： 2400-2412 （in Chinese）. | |
| 8 | 李铮， 徐聪， 张健， 等. 等离子体合成射流激励器高速流场逆向喷流控制［J］. 航空学报， 2022， 43（S2）： 228-235. |
| LI Z， XU C， ZHANG J， et al. Reverse jet flow control by plasma synthetic jet actuator in high speed flow field［J］. Acta Aeronautica et Astronautica Sinica， 2022， 43（S2）： 228-235 （in Chinese）. | |
| 9 | MACK M， NIEHUIS R， FIALA A， et al. Boundary layer control on a low pressure turbine blade by means of pulsed blowing［J］. Journal of Turbomachinery， 2013， 135（5）： 051023. |
| 10 | 叶志贤， 方元祺， 邹建锋， 等. 合成射流激励器流场PIV实验及模态分析［J］. 推进技术， 2021， 42（2）： 258-271. |
| YE Z X， FANG Y Q， ZOU J F， et al. Synthetic jet actuator PIV experiments and modal analysis［J］. Journal of Propulsion Technology， 2021， 42（2）： 258-271 （in Chinese）. | |
| 11 | HOU Z S， XIONG S S. On model-free adaptive control and its stability analysis［J］. IEEE Transactions on Automatic Control， 2019， 64（11）： 4555-4569. |
| 12 | BECKER R， KING R， PETZ R， et al. Adaptive closed-loop separation control on a high-lift configuration using extremum seeking［J］. AIAA Journal， 2007， 45（6）： 1382-1392. |
| 13 | OLIVETT A， CORRAO P， KARAMI M A. Flow control and separation delay in morphing wing aircraft using traveling wave actuation［J］. Smart Materials and Structures， 2021， 30（2）： 025028. |
| 14 | BESELT C， ECK M， PEITSCH D. Three-dimensional flow field in highly loaded compressor cascade［J］. Journal of Turbomachinery， 2014， 136（10）： 101007. |
| 15 | NGUYEN N T， BRIGHT M M， CULLEY D. Adaptive feedback optimal control of flow separation on stators by air injection［J］. AIAA Journal， 2007， 45（6）： 1393-1405. |
| 16 | STAATS M， NITSCHE W， STEINBERG S J， et al. Closed-loop active flow control of a non-steady flow field in a highly-loaded compressor cascade［J］. CEAS Aeronautical Journal， 2017， 8（1）： 197-208. |
| 17 | LANDSBERG T J， KRASNOFF E. An experimental study of rectilinear jet-flap cascades［J］. Journal of Basic Engineering， 1972， 94（1）： 97-104. |
| 18 | FISCHER S， SAATHOFF H， RADESPIEL R. Two-dimensional RANS simulations of the flow through a compressor cascade with jet flaps［J］. Aerospace Science and Technology， 2008， 12（8）： 618-626. |
| 19 | VORREITER A， FISCHER S， SAATHOFF H， et al. Numerical investigations of the efficiency of circulation control in a compressor stator［J］. Journal of Turbomachinery， 2012， 134（2）： 021012. |
| 20 | ZHANG J， DU J， ZHANG M， et al. Aerodynamic performance improvement of a highly loaded compressor airfoil with coanda jet flap［J］. Journal of Thermal Science， 2022， 31（1）： 151-162. |
| 21 | DEUTSCH S， ZIERKE W C. The measurement of boundary layers on a compressor blade in cascade： Part 1—A unique experimental facility［J］. Journal of Turbomachinery， 1987， 109（4）： 520-526. |
| 22 | FISCHER S， SAATHOFF H， RADESPIEL R. Numerical and experimental investigation on a low-speed compressor cascade with circulation control［C］∥Proceedings of ASME Turbo Expo 2008： Power for Land， Sea， and Air. New York： ASME， 2009： 219-228. |
| 23 | 王心毅. 康达喷气叶栅流动分离机理及喷气量控制方法研究［D］. 北京：北京科技大学， 2020. |
| WANG X Y. Research on the Coanda jet cascade flow separation mechanism and jet volume control method［D］. Beijing： University of Science and Technology Beijing， 2020 （in Chinese）. | |
| 24 | 李艺雯. 康达喷气叶型设计方法及其在高负荷压气机中的应用研究［D］. 北京： 中国科学院大学， 2018. |
| LI Y W. Design method of Coanda jet blade profile and its application in high load compressor［D］.Beijing： University of Chinese Academy of Sciences， 2018 （in Chinese）. |
/
| 〈 |
|
〉 |
CJA