In verification of the airworthiness compliance of aircraft cargo compartment smoke detection, simulated smoke generated by smoke generators is often used instead of actual fire smoke in flight tests to reduce the risk. However, previous studies show an obvious difference between actual fire smoke and simulated smoke in terms of response time of smoke detectors, and that the equivalence between actual and simulated smoke must be realized by adjusting the boundary conditions of the smoke generator. Conventional research tried to find the target boundary conditions based on the trial and error method, which is time consuming. In this study, numerical models of actual fire smoke and simulated smoke from the smoke generator were built in Fire Dynamic Simulator (FDS) respectively based on the inverse design method, with the FDS integrated in the Isight platform. The objective function reflecting the equivalence between two kinds of smoke was built, and the Multi-Islands Genetic Algorithm (MIGA) adopted for one-time inverse calculation of the boundary conditions of the smoke generator to achieve the equivalence between two kinds of smoke. The simulation result was experimentally validated and showed that the boundary conditions of the smoke generator calculated inversely can fulfill the equivalence between actual fire smoke and simulated smoke from the smoke generator, thereby providing direct guidance to the compliance of aircraft cargo compartment smoke detection.
CHEN Xiyuan
,
SHAO Ziyan
,
YANG Jianzhong
. Equivalence strategy for aircraft cargo compartment smoke based on inverse design[J]. ACTA AERONAUTICAET ASTRONAUTICA SINICA, 2020
, 41(11)
: 123991
-123991
.
DOI: 10.7527/S1000-6893.2020.23991
[1] DAVID B. Aircraft cargo compartment smoke detector alarm incidents on usregistered aircraft[R]. Washington,D.C.:Federal Aviation Administration, 2000.
[2] Federal Aviation Administration. Airworthiness standards:Transport category airplanes Part 25.858[S]. Washington, D.C.:GPO's Federal Digital System, 2014.
[3] Federal Aviation Administration. Advisory circular AC 25-9A:Smoke detection, penetration, evacuation tests and related flight manual emergency procedures[S]. Washington, D.C.:Federal Aviation Administration, 1994.
[4] SUO-ANTTILA J, GILL W, GRITZO L, et al. An evaluation of actual and simulated smoke properties[J]. Fire and Materials, 2005, 29(2):91-107.
[5] SUO-ANTTILA J, GILL W, GRITZO L. Comparison of actual and simulated smoke for the certification of smoke detectors in aircraft cargo compartments:DOT/FAA/AR-03/34[R]. Washington, D.C.:Federal Aviation Administration, 2003.
[6] BEHLE K. Determination of smoke quantities to be used for smoke detection performance ground and flight tests[C]//25th Congress of the International Council of the Aeronautical Sciences, 2006.
[7] CHEN X Y, SHAO Z Y, YANG J Z. Comparison between actual and simulated smoke for smoke detection certification in aircraft cargo compartments using the CFD method[J]. Fire Technology, 2019, 56(2):469-488.
[8] ZHAO G, WANG L L. Using helium smoke as a surrogate of fire smoke for the study of atrium smoke filling[J]. Journal of Fire Sciences, 2014, 32(5):431-447.
[9] WANG L, ZHAO G. Numerical study on smoke movement driven by pure helium in atria[J]. Fire Safety Journal, 2013, 61:45-53.
[10] MCGRATTAN K B, MCDERMOTT R, HOSTIKKA S, et al. Fire dynamics simulator (Version 5) user's guide[R]. Maryland:National Institute of Standards and Technology, 2010.
[11] MULHOLLAND G W, CROARKIN C. Specific extiction coefficient of flame generated smoke[J]. Fire and Materials, 2000, 24(1):227-30.
[12] KRISHNAN S S, LIN K C, FAETH G M. Extinction and scattering properties of soot emitted from buoyant turbulent diffusion flames[J]. Journal of Heat Transfer, 2001, 123(1):331.
[13] DAVID B. Development of a standardized fire source for aircraft cargo compartment fire detection systems[R]. Washington, D.C.:Federal Aviation Administration, 2006.
[14] SUO-ANTTILA J, GILL W, GALLEGOS C, et al. Cargo compartment smoke transport computational fluid dynamics code validation[R]. Washington, D.C.:Federal Aviation Administration, 2007.
[15] DAVID B, SUO-ANTTILA J. Aircraft cargo compartment fire detection and smoke transport modeling[J]. Fire Safety Journal, 2008, 43(8):576-582.
[16] OZTEKIN E S. Heat and mass transfer due to a small-fire in an aircraft cargo compartment[J].International Journal of Heat and Mass Transfer, 2014, 73(1):562-573.
[17] OZTEKIN E S, DAVID B, LYON R E. Fire induced flow behavior in a ventilated aircraft cargo compartment[C]//13th International Conference and Exhibition on Fire and Materials, 2013.
[18] SUO-ANTTILA J, GILL W, GALLEGOS C, et al. Computational fluid dynamics code for smoke transport during an aircraft cargo compartment fire:transport solver, graphical user interface, and preliminary baseline validation:DOT/FAA/AR-03/49[R]. Washington, D.C.:Federal Aviation Administration, 2003.
[19] LU K H, MAO S H, WANG J, et al. Numerical simulation of the ventilation effect on fire characteristics and detections in an aircraft cargo compartment[J].Applied Thermal Engineering,2017,124(1):1441-1446.
[20] 阳东.狭长受限空间火灾烟气分层与卷吸特性研究[D].合肥:中国科学技术大学,2010. YANG D.Studies in characteristics of stratification and entrainment of smoke layers in channel fires[D]. Hefei:University of Science and Technology of China, 2010(in Chinese).
[21] CHEN S,SHI T,WANG D,et al. Multi-objective optimization of the vehicle ride comfort based on kriging approximate model and NSGA-II[J].Journal of Mechanical Science & Technology, 2015, 29(3):1007-1018.
[22] 曹凡,李迪,李耀民,等. 基于Isight平台的房车空调送风参数优化[J]. 液压与气动, 2019(4):34-41. CAO F,LI D,LI Y M,et al. Optimization of air inlet parameters in RV air conditioner based on isight platform[J]. Chinese Hydraulics & Pneumatics,2019(4):34-41(in Chinese).
[23] 陈弈澄, 齐瑞云, 张嘉芮, 等. 混合小推力航天器轨道保持高性能滑模控制[J]. 航空学报, 2019, 40(7):322827. CHEN Y C, QI R Y, ZHANG J R, et al. High-performance sliding mode control for orbit keeping of spacecraft using hybrid low-thrust propulsion[J]. Acta Aeronautica et Astronautica Sinica, 2019, 40(7):322827(in Chinese).
[24] 田硕,尚建勤,盖鹏涛,等. 带筋整体壁板预应力喷丸成形数值模拟及变形预测[J]. 航空学报, 2019, 40(10):422847. TIAN S, SHANG J Q, GAI P T, et al. Numerical simulation and deformation prediction of stress peen forming for integrally-stiffened panels[J]. Acta Aeronautica et Astronautica Sinica, 2019, 40(10):422847(in Chinese).
CJA