Solid Mechanics and Vehicle Conceptual Design

Modal characteristics and calculation method for flexible rotor system with rubbing constraint

  • YU Pingchao ,
  • CHEN Guo ,
  • WANG Cun ,
  • YANG Mohan
Expand
  • 1. College of Civil Aviation, Nanjing University of Aeronautics and Astronautics, Nanjing 211106, China;
    2. Beijing Institute of Power Machinery, Beijing 100074, China

Received date: 2020-03-27

  Revised date: 2020-04-20

  Online published: 2020-05-28

Supported by

Fundamental Research Funds for the Central Universities (NT2020018); National Natural Science Foundation of China (52005252); National Science and Technology Major Project(2017-IV-0008-0045)

Abstract

The aero-engine Low Pressure (LP) rotor system, usually of large mass, thin and long shaft and long-span supports, has a feature of low stiffness. When rub-impact occurs, the constraint effect must be considered, as it will significantly change the modal characteristics and lead to deviation of dynamic targets from the design value. In this paper, a dynamic modeling method for typical LP rotor systems in aero-engines is proposed based on the beam element method. By combining the harmonic balance and condensation method of degree of freedom in the frequency domain, an effective method is built to solve the nonlinear mode of the complex rotor system. The above methods are achieved using ANSYS and MATLAB software, and successfully applied to the analysis of the modal characteristics of real LP rotors in aero-engines. Results show that the rub-impact significantly increases the modal frequencies of the rotor system. Particularly for the first order modes, the change in the forward whirl and backward whirl modal frequencies can respectively reach 16% and 29%. However, the changes in modal frequencies are always within a certain range and have interval characteristics. While closely related to gyroscopic effect, modal shapes and casing stiffness, the influence of rub-impact on modal frequency is not sensitive to the friction coefficient. Moreover, due to the friction force at the rubbing point, the modal damping of the backward whirl mode may be less than zero when the rub-impact is severe, leading to the unstable backward whirl model.

Cite this article

YU Pingchao , CHEN Guo , WANG Cun , YANG Mohan . Modal characteristics and calculation method for flexible rotor system with rubbing constraint[J]. ACTA AERONAUTICAET ASTRONAUTICA SINICA, 2020 , 41(12) : 224029 -224029 . DOI: 10.7527/S1000-6893.2020.24029

References

[1] 江俊, 陈艳华. 转子与定子碰摩的非线性动力学研究[J]. 力学进展, 2013, 43(1):132-148. JIANG J, CHEN Y H. Advances in the research on nonlinear phenomona in rotor/stator rubbing systems[J]. Advances in Mechanics, 2013, 43(1):132-148(in Chinese).
[2] MA H, YIN F, GUO Y, et al. A review on dynamic characteristics of blade-casing rubbing[J]. Nonlinear Dynamics, 2016, 84(2):437-472.
[3] MUSZYNSKA A. Rotordynamics[M]. New York:Taylor & Francis, 2005.
[4] CHU F, ZHANG Z. Bifurcation and chaos in a rub-impact Jeffcott rotor system[J]. Journal of Sound and Vibration, 1998, 210(1):1-18.
[5] CHEN G, LI C G, WANG D Y. Nonlinear dynamic analysis and experiment verification of rotor-ball bearings-support-stator coupling system for aero-engine with rubbing coupling faults[J]. Journal of Engineering for Gas Turbines and power, 2010, 132(2):022501.
[6] MA H, SHI C Y, HAN Q K, et al. Fixed-point rubbing fault characteristic analysis of a rotor system based on contact theory[J]. Mechanical Systems and Signal Processing, 2013, 38(1):137-153.
[7] MA H, WU Z Y, TAI X Y, et al. Dynamic characteristics analysis of a rotor system with two types of limiters[J]. International Journal of Mechanical Sciences, 2014, 88:192-201.
[8] MA H, ZHAO Q B, ZHAO X Y, et al. Dynamic characteristics analysis of a rotor-stator system under different rubbing forms[J]. Applied Mathematical Modelling, 2015, 39(8):2392-2408.
[9] CHU F, LU W. Stiffening effect of the rotor during the rotor-to-stator rub in a rotating machine[J]. Journal of Sound and Vibration, 2007, 308(3):758-766.
[10] CHU F, LU W. Determination of the rubbing location in a multi-disk rotor system by means of dynamic stiffness identification[J]. Journal of Sound and Vibration, 2001, 248(2):235-246.
[11] WANG C, ZHANG D, MA Y, et al. Theoretical and experimental investigation on the sudden unbalance and rub-impact in rotor system caused by blade off[J]. Mechanical Systems and Signal Processing, 2016, 76:111-135.
[12] HONG J, YU P, ZHANG D, et al. Modal characteristics analysis for a flexible rotor with non-smooth constraint due to intermittent rub-impact[J]. Chinese Journal of Aeronautics, 2018, 31(3):498-513.
[13] 陈艳华, 江俊. 转子/定子碰摩系统的非线性模态及其在干摩擦反向涡动响应预测中的应用[J]. 西安交通大学学报, 2014, 48(5):82-88. CHEN Y H, JIANG J. Determination of nonlinear normal modes with applications to prediction of dry friction backward whirl motion of a rotor/stator rubbing system[J]. Journal of Xi'an Jiaotong University, 2014, 48(5):82-88(in Chinese).
[14] HONG J, YU P, ZHANG D, et al. Nonlinear dynamic analysis using the complex nonlinear modes for a rotor system with an additional constraint due to rub-impact[J]. Mechanical Systems and Signal Processing, 2019, 116:443-461.
[15] 洪杰, 马艳红, 张大义. 航空燃气轮机总体结构设计与动力学分析[M]. 北京:北京航空航天大学出版社, 2014. HONG J,MA Y H, ZHANG D Y. Overall structural design and dynamic analysis of aviation gas turbine[M]. Beijing:Beihang University Press, 2014(in Chinese).
[16] SINHA S K. Dynamic characteristics of a flexible bladed-rotor with Coulomb damping due to tip-rub[J]. Journal of Sound and Vibration, 2004, 273(4):875-919.
[17] ROSENBERG R M. The normal modes of nonlinear n-degree-of-freedom systems[J]. Journal of Applied Mechanics, 1962, 29:7-14.
[18] KRACK M, PANNING-VON S L, WALLASCHEK J. A method for nonlinear modal analysis and synthesis:Application to harmonically forced and self-excited mechanical systems[J]. Journal of Sound and Vibration, 2013, 332(25):6798-6814.
[19] LAXALDE D, SALLES L, BLANC L, et al. Non-linear modal analysis for bladed disks with friction contact interfaces[C]//ASME Turbo Expo 2008. New York:ASME,2008.
[20] CAO D, YANG Y, CHEN H, et al. A novel contact force model for the impact analysis of structures with coating and its experimental verification[J]. Mechanical Systems and Signal Processing, 2016, 70:1056-1072.
Outlines

/