针对高超声速飞行器电静液作动器支路在有限热沉条件下温升、冷却能力衰减和泄漏增长相互耦合,导致作动能力下降和位移跟踪性能退化的问题,提出一种在线退化估计与分层协调控制方法。首先建立电静液作动器支路机液热耦合降阶模型,以作动器输出位移、输出速度、作动缸负载压力和支路集总温度为状态变量,引入有效换热因子、泄漏增长量和作动能力因子描述热沉受限条件下的主要退化影响。然后构造在线退化估计器,利用温度残差修正有效换热因子,利用压力残差修正泄漏增长量,并通过扩张状态观测器估计任务载荷和集总扰动。在此基础上,设计上层热沉性能协调策略和下层作动能力补偿控制策略,上层根据热状态和冷却能力估计分配热沉资源并调节跟踪强度,下层根据作动能力因子和扰动估计量计算电机泵控输入。仿真结果表明,在复合退化场景下,所提方法将位移跟踪均方根误差对比固定基线降低9.33%,最高温度控制在68.030℃。在热载荷变化和参数扰动条件下仍保持较低跟踪误差。结果说明,所提策略能够在发生退化时利用有限热沉保障电静液作动器支路热安全和作动性能。
To address the degradation of pressure response capability and displacement tracking performance caused by the coupled effects of branch temperature rise, cooling-capacity attenuation, and leakage growth in electro-hydrostatic actuators for hypersonic vehicles under finite heat-sink conditions, an online degradation estimation and hierarchical coordinated control method is proposed. First, a control-oriented reduced-order hydro-mechanical-thermal coupling model of the electro-hydrostatic actuator branch is established, in which the actuator output displacement, output velocity, actuator-cylinder load pressure, and lumped branch temperature are selected as state variables. An effective heat-transfer factor, leakage increment, and actuation capability factor are introduced to characterize the dominant degradation effects under heat-sink-limited conditions. Then, an online degradation estimator is constructed, where the effective heat-transfer factor is updated using the temperature residual, the leakage increment is updated using the pressure residual, and the lumped disturbance caused by mission loads and unmodeled dynamics is estimated through an extended state observer. On this basis, an upper-level heat-sink–performance coordination strategy and a lower-level actuation capability compensation control law are designed. The upper layer allocates heat-sink resources and adjusts the tracking intensity according to the estimated thermal state and cooling capability, whereas the lower layer calculates the motor-pump control input according to the actuation capability factor and disturbance estimate. Simulation results show that, under compound degradation scenarios, the proposed method reduces the root-mean-square displacement tracking error about 9.33%, and limits the maximum temperature to 68.030°C. Low tracking errors are also maintained under thermal-load variations and parameter perturbations. These results demonstrate that the proposed method can ensure both thermal safety and actuation performance of the electro-hydrostatic actuator branch under finite heat-sink conditions.
[1]CHEN W, et al.Study of the heat transfer design of an integrated thermal management system for hypersonic vehicles using supercritical nitrogen as expendable coolant[J].[J].Aerospace Science and Technology, 2022, 123(107440):1-13
[2]DINDA S, et al.Heat management in supersonichypersonic vehicles using endothermic fuel: Perspective and challenges[J].ACS Omega, 2021, 6(40):26741-26755
[3]GUO L, et al.Optimization of power and thermal management system of hypersonic vehicle with finite heat sink of fuel[J].Energies, 2022, 15(5332):1-15
[4]QI Y, et al.Review on heat-to-power conversion technologies for hypersonic vehicles[J].Chinese Journal of Aeronautics, 2024, 37(5):148-179
[5]于喜奎, 毛羽丰.高超声速飞机热管理系统控制模型构建与仿真[J].航空动力学报, 2018, 33(3):741-751
[6] ROBERTS R A, et al.Generic aircraft thermal tip-to-tail modeling and simulation[C]//Joint Propulsion Conference and Exhibit. San Diego: AIAA, 2011: 5971.
[7]VAN HEERDEN A S J, et al.Aircraft thermal management: Practices, technology, system architectures, future challenges, and opportunities[J].Progress in Aerospace Sciences, 2022, 128(100767):1-46
[8]JIAO Z, et al.Active load sensitive electro-hydrostatic actuator on more electric aircraft: Concept,design,and control[J].IEEE Transactions on Industrial Electronics, 2022, 69(5):5030-5040
[9]傅昱, 韩旭, 杨锐.电静液作动器设计方法综述[J].北京航空航天大学学报, 2017, 43(10):1939-1952
[10]DU S, et al.Application and progress of high-efficiency electro-hydrostatic actuator technology with energy recovery: A comprehensive review[J].Energy Conversion and Management, 2024, 321(119041):1-24
[11]ZHANG X, et al.Dynamic thermal coupling modeling and analysis of wet electro-hydrostatic actuator[J].Chinese Journal of Aeronautics, 2022, 35(6):298-311
[12]LIU J, et al.Thermal characteristic and analysis of electro-hydrostatic actuator[J].IEEE Access, 2024, 12:34222-34234
[13]ROSHANIAN J, et al.Studies on the thermal behavior of an electro-hydrostatic servo actuator[J].Actuators, 2025, 14(48):1-22
[14]王勇, 郭帅, 杨磊.电静液作动器热力学建模方法及油液温升规律[J].北京航空航天大学学报, 2018, 44(8):1596-1607
[15]XUE L, et al.A simulation-based multi-objective optimization design method for pump-driven electro-hydrostatic actuators[J].Processes, 2019, 7(274):1-13
[16]WANG L, et al.Adaptive actuator fault-tolerant control for non-minimum phase air-breathing hypersonic vehicle model[J].ISA Transactions, 2022, 126:47-64
[17]王忠森, 廖宇新, 魏才盛, 戴婷.高超声速飞行器快速终端滑模保性能容错控制[J].航空学报, 2023, 44(24):1-14
[18]TAN C, et al.Characteristic analysis and model predictive-improved active disturbance rejection control of direct-drive electro-hydrostatic actuators[J].Expert Systems with Applications, 2026, 301(130565):1-13
[19]MA J, YAO Z, YAO J.Fixed-time sliding mode control of electro-hydrostatic actuators with adaptive neural-network compensation[J].Control Engineering Practice, 2025, 165(106616):1-11
[20]LIU J, et al.Nonlinear robust adaptive control of electro-hydrostatic actuators with continuous friction compensation[J].International Journal of Control, Automation and Systems, 2024, 22(4):1225-1237
[21]RAZMJOOEI H, et al.Adaptive fast-finite-time extended state observer design for uncertain electro-hydraulic systems[J].European Journal of Control, 2023, 69(100749):1-14
[22]LAO L, CHEN P.Adaptive sliding mode control of an electro-hydraulic actuator with a Kalman extended state observer[J].IEEE Access, 2024, 12:8970-8982
[23]DANG T D, et al.Output feedback-based neural network sliding mode control for electro-hydrostatic systems with unknown uncertainties[J].Machines, 2024, 12(554):1-22
[24]杨锐, 张磊, 赵健.电静液作动器非线性变阻尼积分滑模控制[J].北京航空航天大学学报, 2024, 50(7):1724-1735