横流中空心锥形喷雾的扩散特性与影响因素

张海滨; 白博峰

doi:10.7527/S1000-6893.2020.23927

航空学报 >

2020 , Vol. 41 >Issue 11: 123927 - 123927

DOI: https://doi.org/10.7527/S1000-6893.2020.23927

流体力学与飞行力学

横流中空心锥形喷雾的扩散特性与影响因素

张海滨 ,
白博峰

展开

西安交通大学化学工程与技术学院动力工程多相流国家重点实验室, 西安 710049

收稿日期: 2020-03-04

修回日期: 2020-03-25

网络出版日期: 2020-04-30

基金资助

国家自然科学基金（51876167）

收起

Droplet dispersion of hollow cone spray in gaseous crossflow: Characteristics and influencing factors

ZHANG Haibin ,
BAI Bofeng

Expand

State Key Laboratory of Multiphase Flow in Power Engineering, School of Chemical Engineering and Technology, Xi'an Jiaotong University, Xi'an 710049, China

Received date: 2020-03-04

Revised date: 2020-03-25

Online published: 2020-04-30

Supported by

National Natural Science Foundation of China (51876167)

Fold

摘要

为了更好地理解和认识空心锥形喷雾射流与横向气流的掺混过程，基于可视化实验测量，针对空心锥形喷雾的初始雾化状态、喷射角度和雾化锥角以及横流速度等因素对空心锥形喷雾射流在横流中的扩散特性进行了系统分析。研究结果表明，随着横流速度的提高，流场中对称反旋涡对（CVP）结构变小，但其稳定性及产生的卷吸气流则是先增强而后减小；提高喷雾初始液滴的动量和数流率，均可以增大射流剪切层的贯穿深度和射流尾迹的伸展高度，同时使流场中CVP的涡量强度增大。基于实验测量结果，建立了空心锥形喷雾垂直入射横流条件下掺混流场液滴群CVP结构特征尺寸和剪切层轨迹的预测关联式。另外针对喷嘴雾化锥角和喷射角度的分析表明，当喷雾初始雾化状态相近时，随着雾化锥角的减小，流场中CVP的水平尺度减小但竖直方向尺度增大且结构更为稳定，同时喷雾液滴的贯穿深度增大；相比喷雾垂直于横流入射，当喷嘴以一定角度逆向横流入射时，CVP结构稳定性减弱，流场剪切层涡结构变大且剪切层区域液滴富集现象减弱，射流尾迹紊乱程度增加，反之，则流场剪切层涡拟序结构变小，射流尾迹现象减弱，CVP结构变小。

关键词： 空心锥形喷雾; 横流; 影响因素; 雾化锥角; 入射角

本文引用格式

张海滨 , 白博峰 . 横流中空心锥形喷雾的扩散特性与影响因素[J]. 航空学报, 2020 , 41(11) : 123927 -123927 . DOI: 10.7527/S1000-6893.2020.23927

Abstract

The influences of different factors on droplet dispersion of the hollow cone spray transversely injected into the crossflow are systematically investigated based on the experimental measurements. The research findings show that as the crossflow velocity increases, the Counter-rotating Vortex Pair (CVP) decreases in size with its stability first increasing and then decreasing. With the increase of Reynolds number and number flow rate of the spray droplets, the depth of the shear layer and the length of the spray wake structures as well as the droplet CVP vorticity increase. The quantitative correlations between the feature sizes of the droplet CVP and the trajectory of the droplet shear layer structure are developed based on the experimental data in terms of the relevant parameters. Furthermore, it is found that as the spray angle decreases, the CVP decreases in width, increases in height, and becomes more stable, and the depth of the spray penetration increases. Compared with the case of vertical injection of the spray, when the spray is injected obliquely against the crossflow, the shear layer vortex becomes larger and the spray wake structures more irregular; the stability of the CVP induced and droplet preferential accumulation on the shear layer are weakened; otherwise, the CVP and the shear layer vortices as well as the wake structures will become smaller.

Key words： hollow cone spray; crossflow; influencing factors; spray angle; injection angle

参考文献

[1] BROUMAND M, BIROUK M. Liquid jet in a subsonic gaseous crossflow:Recent progress and remaining challenges[J]. Progress in Energy and Combustion Science, 2016, 57:1-29.
[2] 薛帅杰, 刘红军, 陈鹏飞, 等. 注气离心喷嘴喷注过程稳定性试验[J]. 航空学报, 2019, 40(7):122697. XUE S J, LIU H J, CHEN P F, et al. Test on spray stability of swirl injector with gas injection[J]. Acta Aeronautica et Astronautica Sinica, 2019, 40(7):122697(in Chinese).
[3] WANG Z G, WANG Y, ZHANG J Q, et al. Overview of the key technologies of combined cycle engine precooling systems and the advanced applications of micro-channel heat transfer[J]. Aerospace Science and Technology, 2014, 39:31-39.
[4] SAHA A, LEE J D, BASU S, et al. Breakup and coalescence characteristics of a hollow cone swirling spray[J]. Physics of Fluids, 2012, 24(12):124103.
[5] 杨亚晶, 何茂刚, 徐厚达. 水冲压发动机的热力循环性能预示[J]. 推进技术, 2009, 30(4):474-478. YANG Y J, HE M G, XU H D. Thermodynamic cycle performance for water ramjet motors[J]. Journal of Propulsion Technology, 2009, 30(4):474-478(in Chinese).
[6] 韩超, 高金属含量镁基燃料水冲压发动机稳态燃烧机理研究[D]. 长沙:国防科技大学, 2011. HAN C. Research on steady-state combustion mechanism in high-metal magnesium-based fuel water ramjet engines[D]. Changsha:National University of Defense Technology, 2011(in Chinese).
[7] 赵军, 单晓亮. 氢氧能源在鱼雷动力系统的应用途径与前景展望[J]. 鱼雷技术, 2011, 19(4):290-298. ZHAO J, SHAN X L. Applications and prospect of hydrogen-oxygen energy in torpedo power system[J]. Torpedo Technology, 2011, 19(4):290-298(in Chinese).
[8] SURYA P R, GADGIL H, RAGHUNANDAN B N. Breakup progresses of pressure swirl spray in gaseous cross-flow[J]. International Journal of Multiphase Flow, 2014, 66:79-91.
[9] KERSTEIN A, MOVAGHAR A, OEVERMANN M. Parameter dependences of the onset of turbulent liquid-jet breakup[J]. Journal of Fluid Mechanics, 2017, 811, R5-1-R5-10.
[10] SURYA P R, ANUBHAV S, GAURAV T, et al. Liquid jet in crossflow-Effect of liquid entry conditions[J]. Experimental Thermal and Fluid Science, 2018, 93:45-56.
[11] BEHZAD M, ASHGRIZ N, KARNEY B W. Surface breakup of a non-turbulent liquid jet injected into a high pressure gaseous crossflow[J]. International Journal of Multiphase Flow, 2016, 80:100-117.
[12] ANUBHAV S, SURYA P R, MADAN M A, et al. Airblast spray in crossflow-Structure, trajectory and droplet sizing[J]. International Journal of Multiphase Flow, 2015, 72:97-111.
[13] 康忠涛, 李向东, 毛雄兵, 等. 液体火箭发动机中气液同轴直流式喷嘴研究综述[J]. 航空学报, 2018, 39(9):022221. KANG Z T, LI X D, MAO X B, et al. Review on gas liquid shear coaxial injector in liquid rocket engine[J]. Acta Aeronautica et Astronautica Sinica, 2018, 39(9):022221(in Chinese).
[14] GHAFFARA Z A, HAMIDB AHA, RASHID M S F M, et al. A review on spray characteristics of effervescent atomizer under various geometrical parameters and operating condition[J]. AIP Conference Proceedings, 2012, 1440:586-590.
[15] ZAREMBA M, MALY M, JEDELSKY J, et al. An experimental analysis of the spraying processes in improved design of effervescent atomizer[J]. International Journal of Multiphase Flow, 2018, 103:1-15.
[16] LEE S, KIM W, YOON W. Spray formation by a swirl spray jet in low speed cross-flow[J]. Journal of Mechanical Science and Technology, 2010, 24(2):559-568.
[17] LYNCH A, BATCHELOR R G, KIEL B, et al. Spray characteristics of a pressure-swirl fuel injector subjected to a crossflow and a coflow[J]. Atomization and Sprays, 2011, 21(8):625-643.
[18] 吴志合, 吴伟亮, 郝世超. 横向流速度对旋流式喷嘴雾化影响的数值分析[J]. 能源技术, 2009, 30(1):1-4. WU Z H, WU W L, HAO S C. Numerical analysis on crossflows velocity affected to swirl jet atomization[J]. Energy Technology, 2009, 30(1):1-4(in Chinese).
[19] ZHANG H B, BAI B F, WANG Y C. Quantitative description of droplet dispersion of hollow cone spray in gaseous crossflow[J]. Experimental Thermal and Fluid Science, 2018, 93:398-408.
[20] 盛刚浩, 张海滨, 白博峰. 空心锥形喷雾与横流掺混特性研究[J]. 推进技术, 2018, 39(1):100-106. SHENG G H, ZHANG H B, BAI B F. Study on characteristics of mixing of hollow-cone spray and crossflow[J]. Journal of Propulsion Technology, 2018, 39(1):100-106(in Chinese).
[21] ZHANG H B, BAI B F, LIU L, et al. Mixing of hollow-cone spray with a confined crossflow in rectangular duct[J].AIAA Journal, 2013, 51(3):615-622.
[22] ZHANG H B, BAI B F, LIU L, et al. Droplet dispersion characteristics of the hollow cone sprays in crossflow[J]. Experimental Thermal and Fluid Science, 2013, 45(1):25-33.
[23] DESHPANDE S S, GAO J, TRUJILLO M F. Characteristics of hollow cone sprays in crossflow[J]. Atomization and Sprays, 2011, 21(4):349-361.
[24] GAO J, TRUJILLO M F, DESHPANDE S. Numerical simulation of hollow-cone sprays interacting with uniform crossflow for gasoline direct injection engines:2011-24-0007[R]. Warrendale:SAE International, 2011.
[25] SÁNCHEZ A L, URZAY J, LIÑÁN A, et al. The role of separation of scales in the description of spray combustion[J]. Proceedings of the Combustion Institute, 2015, 35(2):1549-1577.
[26] CANNY J. A computational approach to edge detection[J]. IEEE Transactions on Pattern Analysis and Machine Intelligence, 1986, 8(6):679-698.
[27] MAHESH K. The interaction of jets with crossflow[J]. Annual Review of Fluid Mechanics, 2013, 45:379-407.
[28] GETSINGER D R, GEVORKYAN L, SMITH O I, et al. Structural and stability characteristics of jets in crossflow[J]. Journal of Fluid Mechanics, 2014, 760:342-367.
[29] FRIC T F, ROSHKO A. Vortical structure in the wake of a transverse jet[J]. Journal of Fluid Mechanics, 1994, 279:1-47.
[30] SMITH S H, MUNGAL M G. Mixing, structure and scaling of the jet in crossflow[J]. Journal of Fluid Mechanics, 1998, 357:83-122.

Options

文章导航

模态框（Modal）标题

摘要

本文引用格式

Abstract

参考文献