航空学报 > 2019, Vol. 40 Issue (7): 322845-322845   doi: 10.7527/S1000-6893.2019.22845

双重未知干扰解耦的多传感器系统偏差校正与状态估计

冯肖雪1, 李淑慧1, 潘峰1,2   

  1. 1. 北京理工大学 自动化学院, 北京 100081;
    2. 北京理工大学 昆明产业技术研究院, 昆明 6501064
  • 收稿日期:2018-12-11 修回日期:2018-12-17 出版日期:2019-07-15 发布日期:2019-01-18
  • 通讯作者: 李淑慧 E-mail:2579371789@qq.com
  • 基金资助:
    国家自然科学基金(61603040,61433003);云南省基础研究计划项目(201701CF00037);云南省科技厅重点研发计划(工业领域)(2018BA070)

Dual unknown interference decoupled multi-sensors bias compensation and state estimate

FENG Xiaoxue1, LI Shuhui1, PAN Feng1,2   

  1. 1. School of Automation, Beijing Institute of Technology, Beijing 100081, China;
    2. Kunming Industry Technology Research Institute INC, Beijing Institute of Technology, Kunming 6501064, China
  • Received:2018-12-11 Revised:2018-12-17 Online:2019-07-15 Published:2019-01-18
  • Supported by:
    National Natural Science Foundation of China (61603040, 61433003); Yunnan Applied Basic Research Project of China (201701CF00037); Yunnan Provincial Science and Technology Department Key Research Program (Engineering) (2018BA070)

摘要: 具有未知干扰输入的随机系统状态估计问题广泛存在于控制、通信、信号处理和故障诊断等领域,但目前的研究成果大多局限于单传感器动态离散系统。针对状态方程含有未知干扰、量测方程含有未知偏差的多传感器系统状态估计问题开展了研究,提出了一种双重未知干扰解耦下的最小方差无偏估计滤波器。首先,建立量测偏差通用演化模型;然后,解耦偏差演化模型中的未知输入,设计最小方差无偏估计器对量测干扰偏差进行估计;之后,利用估计出的量测偏差来校正动态系统测量值;最后,根据量测偏差校正后的系统模型设计最优状态观测器,获得具有最小方差无偏的状态估计。径向飞行控制系统的例子验证了所提方法的有效性,与相关方法的仿真对比反应了所提方法的优越性。

关键词: 未知干扰解耦, 状态估计, 多传感器系统, 最小方差无偏估计, 最优状态观测器

Abstract: Stochastic system state estimate subjects to the unknown interference input widely exists in many fields, such as control, communication, signal processing, and fault diagnosis. However, the current research is mostly limited to the single sensor dynamic discrete system. This paper examines the state estimate of multi-sensors system in which the state equation contains the unknown interference and the measurement equation contains the unknown bias, proposing a dual interference decoupled minimum variance unbiased estimator. Firstly, the general evolution model of measurement bias is established. Then, the unknown input is decoupled from the measurement bias evolution model. After that, the estimated measurement bias is utilized to compensate the dynamic system measurement. Finally, the optimal state observer is designed based on the compensated system measurement model, and the state estimate with minimum variance is obtained. Simulation results of the radial flight controller verified the effectiveness of the proposed method. Comparing with simulated results of the relative methods, the proposed algorithm shows its superiority.

Key words: unknown interference decoupling, state estimate, multi-sensors system, unbiased minimum variance estimate, optimal state observer

中图分类号: